Bedienungsanleitung Axis P3343 (Seite 23 von 68) (Englisch)

613437

Zoom out

Zoom in

Vorherige Seite

1/68

Nächste Seite

AXIS P33 Series - Video & Audio

Audio Settings

Audio Channels

The Audio mode that you select determines the type of audio transmission. The available options are:

Full duplex - Simultaneous two-way audio allowing you to transmit and receive audio (talk and listen) at the same time.

Note: There is no echo cancellation; if feedback loops appear, try moving the microphone or the speaker.

Half duplex - Non-simultaneous two-way audio. Half-duplex mode sends and receives audio in both directions, but only in

one direction at a time.

Simplex - Network Camera speaker only - The speaker connected to the network camera will play audio transmitted from

any web client. This could be used, for example, to provide spoken instructions to a person seen in the network camera. This

mode requires you to use the push-to-talk button.

Simplex - Network Camera microphone only - transmits audio from the network camera to any web client. This can be used

in remote monitoring, and web attractions, to provide live audio from a monitored situation.

Audio Input

Source - Select Microphone for an external microphone or Line for a Line in device, e.g. an audio mixer for multiple

microphones, or a microphone with a built-in amplifier.

Enable microphone power - Microphone power should only be used with electric microphones that have no battery and when

using the internal microphone. This setting should not be enabled when using a dynamic or battery powered microphone.

Input gain - Volume control of the audio input.

Encoding - Select the digital audio encoding format to use.

Sample rate - Select the required sample rate (the number of times per second the sound is sampled). The higher the sample

rate (and the better the audio quality), the greater would be the bandwidth required.

Bit rate - Depending on the selected encoding, set the required bit rate (audio quality). The higher the bit rate, the greater the

bandwidth required.

Alarm level - Event types in the network camera can be set to use this level as a trigger. Each individual event type can be

configured to trigger if the sound level rises above or falls below the set value. The alarm level can be set in the range

0-100%, where 0% is the most sensitive and 100% the least sensitive.

Audio Output

Output gain - Volume control of the line audio output. The output can be used with high impedance headphones or

connected to another amplifier with speakers.

Click Save to save your settings, or click Reset to return to the previous settings.

Audio Clips

Audio clips can be played when an event occurs or manually from the Live View page. Audio clips are created either by

recording sound using the camera's microphone or by uploading a sound file to the camera. Audio clips that have been added

to the network camera are listed in the Audio Clip List page. You can add new clips, play, download, modify and remove clips.

Refer to the online help

for further information.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Axis P3343 Seite 23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info