Bedienungsanleitung Axkid Duofix ISOFIX (Seite 9 von 85) (Deutsch, Englisch, Portugiesisch, Spanisch, Schwedisch)

768006

Zoom out

Zoom in

Vorherige Seite

1/85

Nächste Seite

The easiest way to lift the Duox into the vehicle is with its back rst. Place the child restraint in the vehicle with

the back of the restraint facing the front of the vehicle.

The heels (Y) should be sitting over the edge of the vehicle seat. The indented vertical line (T) on the heel

should align vertically with the end of the vehicle’s seat. If installing in a small vehicle, or if your child does not

require extra leg room, you can instead place the heel upon the vehicle’s seat this will also achieve a more

reclined position.

Note: When installing Duox in the front seat it is possible, but not crucial, for the back of the restraint to have contact

with the dashboard.

To adjust the angle of the child restraint, press the recline adjustment lever (K) to select one of the three

reclining positions. Always choose the most upright position as possible, however your child must be able

to hold their head up on its own, and there should be enough recline to ensure your child’s head does not fall

forward when sleeping. The rule of thumb is that the older the child grows, the more upright the seat can be installed.

Please note that once the installation of the Duox is complete, it will be somewhat more reclined as it sinks into the

vehicle’s seat from tightening seat belts and tether straps.

Positioning The Child Restraint

Rear-Facing 9-25Kg With Seat Belt & Tethers

The headrest on your Duox is equipped with a head support brake. This can be used if you want to keep the

headrest in a xed position. To activate the head support brake, pull the harness adjustment strap until the

headrest is at the desired height, you will hear a faint “click” sound from the headrest as it locks into position.

Check that the headrest can not be pulled down any further and activate the headrest brake by moving the lever (i)

across to the right.

WARNING: Do not pull up the headrest with the parking brake activated.

Placing Your Child In The Seat

Head Support Brake On Headrest

Press the harness adjuster button (I) and pull forward on the shoulder straps (not the shoulder pads) to

completely loosen the harness.

Press the red harness release button on the buckle and unfasten the harness.

Place your child in the car seat. Put your child’s arms in between the shoulder straps so that the straps are

hanging over the chest and stomach.

Pull the shoulder straps together and insert the harness tongues into the crotch buckle.

Pull the harness adjustment strap (J). It’s important that you always pull the harness straight and central when

you tighten the adjustment strap. This will tighten the harness and the headrest will automatically slide down

to the appropriate height.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Axkid Duofix ISOFIX Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info