Bedienungsanleitung Axton A485 (Seite 30 von 52) (Deutsch, Englisch, Französisch)

66170

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

reproduction anyway - will only be playing in the midbass and mid/

high frequency range. This so-called highpass filtered or HPF amplifi-

cation mode also puts less electrical and mechanical 'strain' on your

coaxials and component speaker systems, resulting in an increased

power-handling capacity.

In LOWPASS mode the respective speaker output will only receive

low-pass filtered (LPF) signals resulting in the subwoofer only playing

in the low-end bass frequency range without any unwanted 'smearing'

into the mid/high frequencies.



 



Before you can effect the respective input sensitivity / level adjustments

(GAIN) you first have to select the system appropriate crossover fre-

quencies for all speakers connected by way of the respective filtering

controls marked HIGHPASS and LOWPASS (depending on amplifier

model). 

 rather than by guessing a frequency value!



 Any frequency setting

on the filtering controls will be inactive if the amplification mode switch

remains in position FULL!









The "Loudness" function should also be deactivated.







Depending on amplifier type (mono, 2-channel, 4-channel or a com-

bination thereof), amplification mode (fullrange, highpass or lowpass)

and connecting mode (stereo or mono bridged) it is possible, that only

part of the adjustments described in this manual section are applicable

to your individual car audio system.

If you are using your amplifier in conventional fullrange mode (eg. with a

soundboard), you may skip paragraph "1. Crossover Frequency Settings"

and go directly to "2. Sensitivity Adjustments".

In case you are using your new amplifier(s) in a multi-channel amplifier

system with highpass-filtered front and/or rear satellites and/or a

lowpass-filtered subwoofer, we recommend you to read the complete

section "Controls & Adjustments" before you start adjusting any of the

frequency or level controls.

However, it is recommended to keep to the practical and logical se-

quence of the frequency and level adjustments as described in this

manual section.



The AXTON models A1500, A2150 and A485 do not only offer conven-

tional fullrange amplification: You also have the choice of highpass or

lowpass amplification mode, enabling you to drive your car audio speakers

in the specific frequency range where they will perform best.

In HIGHPASS mode, the dashboard, door and rear shelf speakers (usually

between10 and 16 cm diameter) - which do not give you strong bass

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Axton A485 Seite 30

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info