Bedienungsanleitung Baby Lock Aventura - BLMAV (Seite 190 von 204) (Englisch)

661182

190

Zoom out

Zoom in

Vorherige Seite

1/204

Nächste Seite

Troubleshooting

A-14

■ While sewing

The sewing light

does not come on.

The sewing light is damaged. Contact your authorized Baby Lock retailer. –

“Light” is set to “OFF” in the settings screen. Change the setting to “ON”. B-15

Embroidery unit

does not operate.

Embroidery unit is not attached correctly. Reattach the embroidery unit correctly. B-54

Embroidery frame was attached before the unit

was initialized.

Remove the embroidery frame, and then

perform the initialization process correctly.

B-55

Symptom Probable Cause Remedy Reference

Machine does not

operate.

“Start/Stop” button was not pressed. Press the “Start/Stop” button. B-35

The bobbin winder shaft is pushed to the right. Move the bobbin winder shaft to the left. B-18

There is no pattern selected. Select a pattern. B-35

Presser foot is not lowered. Lower the presser foot. B-2

“Start/Stop” button was pressed with the foot

controller attached.

Remove the foot controller, or use the foot

controller to operate the machine.

B-37

The “Start/Stop” button was pressed while the

machine is set for the sewing speed controller

to control the zigzag stitch width.

Use the foot controller instead of the “Start/

Stop” button to operate the machine, or set the

“Width Control” to “OFF” in the settings screen.

B-13

Needle breaks.

Needle is installed incorrectly. Reinstall the needle correctly. B-31

Needle clamp screw is not tightened. Tighten the needle clamp screw. B-31

Needle is turned or bent. Replace the needle. B-31

Using improper needle or thread for the

selected fabric.

Check the “Fabric/thread/needle combinations”

chart.

B-30

Wrong presser foot was used. Use the recommended presser foot. B-34

Upper thread tension is too tight. Adjust the thread tension. B-41

Fabric is pulled during sewing. Do not pull the fabric during sewing. –

Spool cap is set incorrectly. Check the method for attaching the spool cap,

then reattach the spool cap.

B-18

There are scratches around the opening in the

needle plate.

Replace the needle plate, or consult your

authorized Baby Lock retailer.

A-8

There are scratches around the opening in the

presser foot.

Replace the presser foot, or consult your

authorized Baby Lock retailer.

B-33

There are scratches on the bobbin case. Replace the bobbin case, or consult your

authorized Baby Lock retailer.

A-2

Needle is defective. Replace the needle. B-31

A bobbin designed specifically for this machine

is not used.

Incorrect bobbins will not work properly. Only

use a bobbin designed specifically for this

machine.

B-18

Upper threading is incorrect. Check the steps for threading the machine and

rethread the machine.

B-24

Bobbin is set incorrectly. Reset the bobbin correctly. B-21

Presser foot is attached incorrectly. Attach the presser foot correctly. B-33

Screw of the presser foot holder is loose. Securely tighten the screw of the presser foot. B-34

Fabric is too thick. Use fabric that the needle can pierce when the

handwheel is turned.

B-30, S-4

Symptom Probable Cause Remedy Reference

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Baby Lock Aventura - BLMAV Seite 190

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Baby Lock Aventura - BLMAV

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info