Bedienungsanleitung Baby Lock Destiny - BLDY (Seite 199 von 225) (Englisch)

661183

199

Zoom out

Zoom in

Vorherige Seite

1/225

Nächste Seite

TROUBLESHOOTING

392

■ After sewing

Problem Cause Solution Page

Thread tension is

incorrect.

Upper threading is incorrect. Check the steps for threading the machine and

rethread the machine.

Bobbin is set incorrectly. Reset the bobbin. (If needle plate was

removed, reinstall needle plate and tighten

screws prior to installing bobbin case.)

Using improper needle or thread for the

selected fabric.

Check the “Fabric/Thread/Needle

Combinations” chart.

Presser foot holder is not attached correctly. Reattach the presser foot holder correctly. 69

Thread tension is set incorrectly. Adjust the thread tension. 90, 287

Bobbin thread is incorrectly wound. Use a correctly wound bobbin. 52

Needle is turned, bent or the point is dull. Replace the needle. 73

A bobbin designed specifically for this

machine is not used.

Incorrect bobbins will not work properly. Only

use a bobbin designed specifically for this

machine.

Character or

decorative patterns

are misaligned.

Pattern adjustment settings were set

incorrectly.

Revise the pattern adjustment settings. 174

Pattern does not turn

out.

Wrong presser foot was used. Attach the correct presser foot. “STITCH SETTING

CHART”

Did not use a stabilizer material on thin fabrics

or stretch fabrics.

Attach a stabilizer material. 173

Thread tension is set incorrectly. Adjust the thread tension. 90, 287

Fabric was pulled, pushed or fed at an angle

while it was being sewn.

Sew while guiding the fabric with your hands

so that the fabric is fed in a straight line.

The thread is tangled, for example, in the

bobbin case.

Remove the tangle thread. If the thread is

tangled in the bobbin case, clean the race.

Embroidery pattern

does not sew out

correctly.

Thread is twisted. Use scissors, etc., to cut the twisted thread

and remove it from the bobbin case, etc.

—

Thread tension is set incorrectly. Adjust the thread tension. 90, 287

Fabric was not inserted into the frame

correctly (fabric was loose, etc.).

If the fabric is not stretched tight in the frame,

the pattern may turn out poorly or there may

be shrinkage of the pattern. Set the fabric into

the frame correctly.

244

Stabilizing material was not attached. Always use stabilizing material, especially with

stretch fabrics, lightweight fabrics, fabrics with

a coarse weave, or fabrics that often cause

pattern shrinkage. See your authorized Baby

Lock retailer for the proper stabilizer.

242

There was an object placed near the machine,

and the carriage or embroidery frame hit the

object during sewing.

If the frame bumps something during sewing,

the pattern will turn out poorly. Do not place

anything in the area where the frame may

bump it during sewing.

259

Fabric outside the frame edges interferes with

the sewing arm, so the embroidery unit cannot

move.

Reinsert the fabric in the embroidery frame so

that the excess fabric is away from the sewing

arm, and rotate the pattern 180 degrees.

244

Fabric is too heavy, so the embroidery unit

cannot move freely.

Place a large thick book or similar object under

the arm head to lightly lift the heavy side and

keep it level.

—

Fabric is hanging off the table. If the fabric is hanging off the table during

embroidery, the embroidery unit will not move

freely. Place the fabric so that it does not hang

off the table or hold the fabric to keep it from

dragging.

259

Fabric is snagged or caught on something. Stop the machine and place the fabric so that

it does not get caught or snagged.

—

Embroidery frame was removed during sewing

(for example, to reset the bobbin). The presser

foot was bumped or moved while removing or

attaching the embroidery frame, or the

embroidery unit was moved.

If the presser foot is bumped or the

embroidery unit is moved during sewing, the

pattern will not turn out. Be careful when

removing or reattaching the embroidery frame

during sewing.

266

Stabilizer is incorrectly attached, for example,

it is smaller than the embroidery frame.

Attach the stabilizer correctly. 242

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Baby Lock Destiny - BLDY Seite 199

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Baby Lock Destiny - BLDY

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info