661218
19
Zoom out
Zoom in
Vorherige Seite
1/43
Nächste Seite
G
E
T
T
I
N
G
R
E
A
D
Y
18
Loading Position
1. Hold the bobbin case with one hand. Insert the fully wound
bobbin into the bobbin case so that the bobbin turns in a
clockwise direction. (Fig. A)
2. Pull the thread through the slot of the bobbin case. (Fig. B)
3. Slide the bobbin thread toward the left so the thread enters
under the tension spring and through the cut out area direct-
ly above the bobbin case double-eye thread guides. (Fig. C)
4. Insert the end of the bobbin thread from right to left through
the bobbin case double eye thread guides. (Fig. D)
5. Pull out approximately 10” (25cm) of bobbin thread.
6. Press and hold the positioning button for approximately 2
seconds to set the machine to the bobbin loading position.
7. Hold the bobbin case by the hinged latch. Align the double
eye thread guides of the bobbin case with the groove (yellow
dot marking) of the shuttle race. Insert the bobbin case fully
into the shuttle race and release the latch. (Fig. E)
A
B
C
D
E
Yellow Mark
Inserting the Bobbin
Press and hold the positioning button for approximately 2 sec-
onds and the machine will automatically move to the loading
position. The yellow LED light will now be lit.
The loading position will adjust the machine to enable one of the
following procedures:
1. Insert or remove the bobbin case
2. Replace the latch wire
3. Replace the needle
IMPORTANT: The needle should be in the UP position, the
thread cut, and the fabric removed before setting machine to the
loading position.
NOTE: The blue or green LED light will also be lit, depending
on which needle position was selected prior to pressing the posi-
tioning button for the loading position. If the presser foot is in the
up position or if the side door is open then the orange LED light
will flash while the yellow LED is lit.
10" (25cm)
19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Baby Lock Sashiko - BLQK wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info