10
hold 1 to 2 cm below the cutting
length. Then, using the clipper, cut
the section of hair steeply and at an
angle to create a saw-toothed ‘edge’.
Patterning your hair and giving it
a perfect nish
Your clipper also comes with an
exclusive special short cut blade. Its
narrow size enables you to pattern
your hair and beard with great
accuracy.
To click it into place, please refer
to the part entitled “Removable
blades”.
MAINTENANCE
Remove the cutting guide after each
use.
Cleaning the clipper blades
regularly will maintain their optimal
performance.
Removable blades
To make cleaning easier, the BaByliss
clipper blades can be removed. Make
sure the clipper is turned o. Hold
the clipper with the blades pointing
up and remove them by pressing the
top of the blade. (Fig. 7)
Brush the blades using the cleaning
brush to remove any hair.
Self-lubricating blades
The blades of your clipper have
a reservoir pad that dispenses
the amount of oil necessary for
your clipper to operate properly,
every time. It is nevertheless
recommended that you occa-
sionally rell, when you notice the
clipper isn’t performing as well.
Remove the blades as described
above.
Carefully squeeze a few drops of
BaByliss oil onto the pad. (Fig. 8)
Then put the blades back on the
clipper.
BaByliss oil is specially formulated
for clippers, it will not evaporate or
slow the blades down.
You can get new blades when these
are worn or damaged.
TO OPERATE NOSE AND EAR
TRIMMER
1. To insert battery, remove
compartment cover by turning
bottom section of trimmer to the
left, then pulling straight down.
Insert one AA alkaline battery,
positive end up (Fig. 9). If you are
not going to use the unit for a long
period of time, or if the battery is
dead, remove the battery from the
unit. This will increase the life of
your trimmer.
2. After inserting battery, close
battery compartment and turn
unit to ON position (I).
To eliminate undesirable nose and
ear hairs
Gently insert trimmer head into the
ear or nose and cut the hairs.
MAINTENANCE
Turn unit to OFF (0) position.Remove
top housing by turning the top
of the trimmer to the right and
lifting up (Fig. 10). Remove hair(s)
accumulated on the blades after
each use. Rinse trimmer blade under
water without immersing the head
as shown (Fig. 11).
Allow to dry. Ensure that the cutting
blade remains centered. Then
reassemble and turn to the left until
arrows line up.
Do not use the appliance in the
shower or in the bath.
