E852XE BEARD AND
MOUSTACHE TRIMMER
1. 1 cutting guide for 74
lengths (from 0.4mm to
15mm, in 0.2mm increments)
2. 32mm blade
Moveable blade:
- Exclusive three-dimensional
etching process: for an
exceptionally sharp cutting
edge.
- CMS (Chrome-Molybdenum-
Stainless Steel): ultra-
hardwearing and 100%
stainless steel blade.
Fixed Blade:
- TITANIUM coating: for
increased longevity
These 2 technologies provide
a perfect surface condition
and combining them is ideal
for reducing the friction
coecient.
3. 1 special ‘3-day beard’
cutting guide
4. 1 shaving head
5. ON/OFF button
6. LCD screen that displays:
7. Selected length in mm
8. Battery charge level
9. Cutting length setting
10. Plug for use on the mains
and for charging
11. Cleaning brush
IMPORTANT INFORMATION
REGARDING THE NI-MH
BATTERIES OF THIS UNIT
To obtain and maintain the
longest battery autonomy
possible, allow it to charge
for 16 hours before using it
for the rst time and then
approximately every three
months. Full autonomy of
the unit will only be obtained
after three complete recharge
cycles.
CHARGING THE TRIMMER
1. Plug the cord into the unit
and connect the transformer.
Before using the trimmer
for the rst time, allow it to
charge for 16 hours. Make
sure the trimmer’s switch is in
the OFF position.
2. The LCD screen will light up
and a battery icon with a
bar will indicate the battery
charge level.
3. A full charge provides a
minimum of 30 minutes’ use
of the trimmer.
4. Allow 90 minutes for
recharging.
USE ON THE MAINS
To use the trimmer on the
mains, plug the cord directly
into the unit.
Plug the trimmer, in the OFF
position, into the mains and
switch ON (If the battery is very
weak, wait about 1 minute).
IMPORTANT! Use only the
transformer provided with the
trimmer Ref. E852XE Voltage =
3.6V – 1000mA.
ENGLISH
