10
for you. Special care should be
taken when cutting hair in these
areas to prevent injury.
• Remove any jewels like earrings,
necklaces, etc.
• Use your Easy Cut clipper
on clean, dry and carefully
untangled hair for best cutting
results.
• If your hair is long, cut it rst
using the scissors and comb.
• Make sure the unit is suciently
charged, or plugged into the
mains.
CUTTING AND MAINTAINING
SHORT HAIR CUTS
• Turn the Easy Cut clipper using
the ON/OFF switch located on
the top of the unit. The blades
will start to move and the green
LED will come on.
• Move the clipper slowly and
smoothly around the scalp
beginning at the top of your
head.
• The clipper can be used in any
direction to cut your hair, but use
gentle pressure. If you feel the
unit resisting, turn it o, empty*
any hair that may have collected
in the clipper and start clipping
your hair again.
*Hair will collect inside the blade
ring and you may need to empty
it before you nish cutting your
hair. In this case, switch the clipper
o and remove the hair by gently
tapping on the top of the clipper
and using the cleaning brush.
• If using on zones where there
are folds of skin, pull the skin
taut with your other hand before
continuing to cut.
• If you would like a grade 0 cut,
the clipper can be used without
a comb guide attached.
CLEANING AND MAINTAINING
THE EASY CUT CLIPPER
To ensure optimum performance
of your clipper, we recommend
cleaning the clipper after every
use.
• Remove the comb guide, rinse
under running water and dry it
thoroughly before storing.
• Never place the clipper under
running water.
• Using the cleaning brush,
thoroughly clean all hair from
the inside of the blade ring.
• Before each use, we recommend
adding a few drops of oil
(provided) in the 3 oil slots inside
the blade ring. (g. 7)
• Wipe the outside of the clipper
with a damp cloth and dry
thoroughly before storing it.
USING THE FINISHING TRIMMER
The nishing trimmer operates on
2 AA batteries.
Open the battery compartment
cover by pushing it down and
sliding it open. Insert 2 AA
batteries as indicated in the
battery compartment. Replace
the cover by pushing it upward
until it clicks into place.
NOTE: If the clipper remains
unused for a while or if the
batteries have run down, remove
them from the unit. These
