Bedienungsanleitung Babymoov A002028 (Seite 9 von 48) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch)

715671

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

IN CASE OF ANY LITTLE PROBLEMS

The bottle warmer doesn't heat up:

- check the "On" button to make sure it is properly switched on,

- check that the appliance is properly plugged in,

- check that there is not too much scale in the tank, and de-scale if necessary.

The warming cycles are too short or too long:

too much or too little water used. Adjust the quantity of water according to the temperature you want:

more water = hotter

less water = cooler

MAINTENANCE

Cleaning:

- Wait until the bottle warmer is cold before cleaning it.

- Always unplug the appliance before cleaning it.

- Never submerge the appliance in water, and don't fill it right up with water.

- Never use detergents to clean the appliance.

- Use a slightly damp cloth to clean the inside and outside.

- Adaptor ring, measure and baskets for jars can be washed in the dishwasher.

De-scaling:

Do not use any de-scaling products. Depending on the quality of water used and after a certain period of time, a layer of scale may

build up in the tank (b). In order for the sterilizer to work properly, the tank needs to be de-scaled regularly.

Proceed as follows: Mix 100 ml hot water with 100 ml white vinegar and pour it all into the tank (b). Leave to act for 30 minutes then

empty the appliance. Then use a damp cloth to clean it.

TULIPE HOME/CAR BOTTLE-WARMER • Instructions for use

Amount of water

in the baby bottle

Amount of water to put

in the measuring device

for a baby bottle

prepared with

warm water

60 ml 4 ml

90 ml 5 ml

120 ml 5 ml

150 ml 5 ml

180 ml 5 ml

210 ml 5,5 ml

240 ml 5,5 ml

270 ml 6 ml

300 ml 6,5 ml

330 ml 6,5 ml

Jar

Amount of water

to put in the measuring

device for a jar

120 g 9 ml

200 g 12 ml

250 g 14 ml

Using the appliance in the car

Stop the vehicle and let the engine running.

8. Put the bottle-warmer on a flat and steady surface inside your vehicle. Plug the cigarette-lighter adapter (f) into to the bottle-

warmer's power cable (g).

9. Plug the adapter (f) into the cigarette-lighter. Fill up the measuring device (a) with water by following the doses reported here

below and then pour the water into the warming tank (b).

Repeat the steps above, from 3 to 7.

7. The bottle-warmer turns off automatically when the heating cycle is over. At the same time, the backlight ring (h) will turn green

for a minute, which means that the bottle is ready.

Take out the bottle or jar straight away with a pair of tongs or a cloth as they are hot.

To avoid the risk of burns, always check the temperature of the food before giving it to your baby. If you are using a baby bottle,

shake it well to mix the milk. Pour a drop onto the inside of your

wrist to check how warm it is. If you are using a jar, mix the contents and taste it to make sure it is not too hot.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Babymoov A002028 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info