Bedienungsanleitung Babymoov Babydoppler Connect - A062201 (Seite 14 von 44) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch)

715625

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite

or clean with a soft dry cloth.

Your Babydoppler Connect device is fragile and should be handled with care. The gel must be

removed after each use of the doppler. These precautions will prolong the life of your doppler.

The user must also make sure before handling it that the doppler does not present any obvious

damage which might affect its safety and the correct functioning of the device.

The typical operation time of the batteries is up to 20 days. This equipment expected service

life is 10 years. Before operating this equipment make sure to wait 10 minutes in order to let it

warm or cool and reach ambient temperature.

It is recommended to check the proper functioning of the device at monthly intervals. If there is

any proven damage, it is advisable to replace the doppler before use. Carry out regular safety

tests to make sure that the device is insulated against leakage current, including measuring

the leakage current. The recommended frequency is once every two years or according to the

directives of the country in which the device is used.

The device and accessories are to be disposed of according to local regulations after their

service lives. They can be returned to the dealer or the manufacturer for recycling or proper

disposal.

The Babydoppler Connect and its mobile application do not provide precise data on the foetal

cardiac rhythm but simply a sound recording. If the foetal cardiac rhythm is not credible, there

are other methods such as the stethoscope to check it. Only the doctor is authorised to

carry out this kind of measure.

11. IN CASE OF PROBLEMS

Generally speaking, in case of any problems switch off your doppler, remove the batteries and

unplug the cables supplied. Plug the cables back into your smartphone or tablet and your

doppler, re-install the batteries and switch your doppler back on.

If the following problems arise again when using your doppler, try to solve them by using the

proposed solutions.

12. WARRANTY

Babydoppler Connect application was developed for the new generation of smartphone and

tablets and new versions of iOS/Android operating systems. BABYMOOV and LATL TECHNO-

Problems Possible reasons Solutions

The sound is

weak

The volume is too low.

The batterie is worn out.

You did not apply contact gel.

Adjust the sound volume of the

doppler.

Change the batteries.

Apply gel to the probe.

There is noise The volume is too high.

The power is low.

Disturbance from an external signal.

Adjust the sound volume of the

doppler.

Change the batteries.

Make sure your smartphone or

tablet is in Airplane Mode.

There is low

sensitivity

The probe is wrongly positioned.

You did not apply contact gel.

Adjust the position of the probe.

Apply gel to the probe.

You cannot

hear or record

the baby’s

heartbeat

The position of the probe is incorrect.

You did not apply contact gel.

The cables are not connected correctly.

Adjust the position of the probe.

Apply gel to the probe.

Make sure that the cables are

correctly connected.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Babymoov Babydoppler Connect - A062201 Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info