Bedienungsanleitung Balance Meteo RF-WS31 - 695159 (Seite 4 von 7) (Englisch)

606445

Zoom out

Zoom in

Vorherige Seite

1/7

Nächste Seite

clock mode.

Setting The Daily Alarms :

} In time mode, press ”ALM SET (B5)” button one time, and the “ ”icon appears, again press and hold down the

“B2” button for 3 seconds until “AL” hour icon starts to flash, now use ”+(B2)” or "-(B1) “ buttons to set your want

time, and press “B5” to confirm your setting, ” AL “ minute display start to flash, press ”+(B2)” or “–(B1)” buttons to

set you want time. And press “B5” to confirm your setting.

} If you want cancel the alarm, please change the alarm mode and press “B5 “ button one time to cancel the alarm,

and the “ ”icon disappears .

To Use Snooze Alarm:

When time reaches your set alarm time ,your clock will give beep sound to wake up, the “ ”icon will flash..

} Press” SNOOZE/LIGHT(B4) ” button once to stop the alarm temporarily, the “ ” icon keeps flashing ,the alarm

will beep again in 5 minutes.

} To stop the alarm , press anything button once ,the alarm beep will stop and the “ ” icon become static ,alarm will

beep again same time next day.

Alarm Duration : 2 minutes.

Snooze Duration: 5 minutes

Reception Of The Radio Signal :

} When you insert the batteries, all the icons on the LCD display will briefly up for 3 seconds, and you will hear a

beep tone.

} The Receiver (clock ) will now start to make a connection to the wireless remote sensor, this operation takes

about 3 minutes and is displayed by flashing reception RF symbol “ “ on the LCD display .

} After receiver has created a connection to the wireless remote sensor ( after 3 minutes ), it will then begin the

automatic reception of the DCF radio signal , this operation takes up to 7 minutes and is display by flashing radio

mast symbol “ ” on the LCD display.

} If reception is successful, then the radio controlled icon ” “ will appear continuously on the LCD display.

} The Receive automatically must scan the DCF signal at 1:00 a.m.2:00 a.m.3:00 a.m .everyday, if it receiver DCF

signal at 3:00 a.m. it will stop receiving until 1:00 a.m. next day .but if it fail reception at 3:00 a.m,it will repeat again

at 4:00 a.m.5:00 a.m. This procedure is repeated automatically up to 5 times.

} If this automatic process is unsuccessful, then use a sharp object to press the “ RESET (B6) “button on the

Receiver.

Remarks :

} A flashing radio mast symbol indicates that the DCF signal reception has started.

} A continuously displayed radio mast symbol indicates that the DCF was received successfully.

} We recommend a minimum distance of 2.5 meters (8.2 Feet) to all sources of interference such as televisions or

computer monitors.

} Radio reception is weaker in rooms with concrete walls (e.g. in cellars) and in offices. In extreme cases, place the

system at a window.

} As there is less atmospheric interference at night, radio reception is normally possible at this time. A single

synchronization each day is sufficient to keep the time display accurate to one second.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Balance Meteo RF-WS31 - 695159 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Balance Meteo RF-WS31 - 695159

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info