Bedienungsanleitung Balay 3VF341ND (Seite 19 von 32) (Englisch)

21899

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

Programme interruption

Carefully open the door, it could happen

that water splashes out of the

appliance. Only open completely when

the spray arm no longer turns.

If the programme is already in “drying”

mode, an acoustic signal reminds you

to close the appliance door or to abort

the programme.

Switch OFF the main switch 1 .

Indicator light goes out. The programme

remains stored.

If warm water is connected or if the

machine is already heated up and the

appliance door has been opened, leave

the door slightly ajar, then close it,

otherwise the appliance door can jump

open through the expansion.

In order to continue the programme

flow, switch the main switch ON again

and close the door.

Cancel programme (Reset)

Only when the master switch is ON.

Press the

A and C programme

buttons simultaneously and hold them

pressed for approx. 3 sec.

The programme continues for approx.

1 min.

The PROGRAMME END indicator and

the indicator for the programme that

has just been terminated light up.

Set main switch 1 to OFF.

Close the detergent compartment 30 .

To restart the dishwasher, set main switch

1 to ON again and select desired

programme.

Changing the programme

It is possible to change the programme

selection after you have switched the

dishwasher on, provided that you have not

yet closed the door.

If it is necessary to change the programme

after this, the programme cycle that has

already begun (e.g. washing) will still carry

on to the end.

Maintenance and care

You can help prevent faults by checking

and maintaining your appliance regularly.

This will save time and reduce problems.

Therefore you should occasionally

examine the inside of your dishwasher.

Overall condition of the

appliance

Check the rinsing compartment for grease

and limescale deposits.

If you find any deposits:

Fill the detergent dispenser with

detergent. Start the empty appliance

with the programme which has the

highest rinsing temperature.

Clean the door seal:

Wipe the door seal regularly with

a damp cloth and remove any deposits.

Dishwasher salt

Check the LOW SALT indicator 4 or

24 . Top up with salt, if required.

Rinse-aid

Check the LOW RINSE-AID indicator

5 on the front panel or the level

indicator on the rinse-aid container

29 . Top up with rinse-aid, if required.

Filters

The filters 25 prevent larger remnants of

food or other objects from getting inside

the pump. This residue can occasionally

clog up the filters.

The filter system consists of a filter

cylinder, a flat fine filter and, depending on

the model, a microfilter (*).

Inspect the filters for obstructions every

time the dishwasher has been used.

By unscrewing the filter cylinder, you

can remove the filter system. Remove

any food remnants and clean the filters

under running water.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Balay 3VF341ND Seite 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Balay 3VF341ND

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info