Bedienungsanleitung BandG Zeus Touch (Seite 40 von 66) (Englisch)

658655

Zoom out

Zoom in

Vorherige Seite

1/66

Nächste Seite

Ethernet (NETWORK port) | Zeus Touch installation manual

Ethernet setup

No special setup is required for establishing an ethernet network, it is all ‘plug and play’ . An

NEP-2 connected between an Zeus Touch and another network module (e.g. BSM-1) will

automatically start working, and relay data between the two devices.

Diagnostics

The UDB (User Data Base) tab, on the diagnostics page, provides information on Ethernet

activity.

Databases

The upper table gives an account of the various automatically synchronised databases that

ensure B&G display units (Zeus Touch, Zeus, plus Simrad NSS, NSE, and NSO) are all using the

same user settings and data. Each unit stores the database locally, so that all information is

available if the device is run in standalone. Databases can become unsynchronised when one

or more displays in a multi display network are not powered up while other displays are being

operated. Creation of waypoints, routes, tracks, and altering global settings all a ect databas-

es. When the tick box ‘Dirty’ is ticked, the unit has identi ed that it’s database is older than that

of another device on the network. The tickbox should clear within seconds of both devices

being powered up, and the databases synchronising. If it does not clear, it is recommended

that all devices have the power cycled.

IP addresses

The lower table shows the IP address of the display being viewed (top of list), the Master

display (with a tick next to it), and any other displays in a multi display network. The function

of the Master is invisible to the end user - It manages database synchronisation, however this

task automatically shifts to another display if the current master is shut down. The IP address

list only refreshes after all devices on the network have been powered down - a single device

that is shutdown on the network will not be removed from the table shown on other devices.

When powering up a system that has been completely shutdown, a network connectivity

issue can be identi ed if a display does not show any other IP addresses than it’s own.

The ‘UDB version’ is dependant on the software version installed on the display. It will never

change on it’s own, unlike the ‘Version’ of the Databases on the upper table. It is preferable to

have all USB versions the same. This can usually be acheived by loading the latest software on

to your display (see “Applying Software Updates” on page 51).

Module network light

The network LED on modules such as NEP-2, BSM-1, and RI10, can be useful for determining if

the network is fundamentally operational. No light indicates no connection. A rapidly blinking

green LED means the network module is communicating with another device.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

BandG Zeus Touch Seite 40

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von BandG Zeus Touch

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info