Bedienungsanleitung BandG Zeus2 Glass Helm (Seite 10 von 52) (Englisch)

658689

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

8 |

Hardware installation | Zeus Glass Helm Installation Manual

Hardware installation

Mounting location

Choose the mounting locations carefully before you drill or cut. Be sure to leave a direct path

for all of the cables.

Ensure that any holes cut are in a safe position and will not weaken the boat’s structure. If in

doubt, consult a quali ed boat builder.

Before cutting a hole in a panel, make sure that there are no hidden electrical wires or other

parts behind the panel.

Do not mount any part where it can be used as a hand hold, where it might be submerged, or

where it will interfere with the operation, launching or retrieving of the boat.

Choose an area where the unit will not be subjected to excessive vibration, or heat.

Choose a location that will not expose the unit to conditions that exceed the IP rating.

Leave su cient clearance to connect all relevant cables.

For overall width and height requirements, please see “Dimensioned drawings” on page 46.

Warning: When installing, ensure appropriate safety equipment is used, e.g. ear mu s,

protective glasses, gloves and a dust mask.

Power tools may exceed safe noise levels, and can cast o dangerous protectiles.

The dust from many materials commonly used in boat construction may cause irritation or

damage to eyes, skin, and lungs.

Processor installation

Hold the processor up to the desired location on the mounting surface, and with a pencil or

marker, trace the keyhole at each of the four mounting tabs. Remove the processor and mark

the centre of the narrow end (top) of each keyhole.

The supplied fasteners can be used when installing the processor to a wooden or  breglass

bulkhead. For steel or aluminium it may be preferable to use machine screws with lock nuts.

For supplied fasteners, pre-drill the holes at the marked points with no larger than a 2.7 mm

drill bit. When drilling in to  breglass covered in gelcoat, it is recommended to carefully

remove the gelcoat layer with a small countersink bit after the hole has been drilled. This will

prevent the gelcoat from cracking as the fastener is tightened.

= PHILLIPS #2 (PH2)

ZC1 and monitor installation

Refer to the mounting templates supplied with the ZC1 and monitors. ZM series monitors

include installation instructions that should be carefully read before commencing with

installation. While installations using touch monitors do not technically require the ZC1 for

general operation, they are recommended, especially in integrated autopilot installations

where a physical STBY/AUTO key is required during commissioning. Fixed keypads also o er

more accurate control in rough operating conditions. Ensure the ZC1 is conveniently located

within easy reach of helm seating or standing position.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

BandG Zeus2 Glass Helm Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von BandG Zeus2 Glass Helm

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info