Bedienungsanleitung Barbecook BRAHMA K INDUCTION (Seite 22 von 60) (Alle Sprachen)

616256

Zoom out

Zoom in

Vorherige Seite

1/60

Nächste Seite

22 www.barbecook.com

TIPS ON USING YOUR BARBECUE

• To prevent the appliance from going

into standby mode because of over-

heating, we recommend that you

set the temperature to 180°C using

the “TEMP” function.

• You can use pots and pans with a

flat base and a diameter between

16 and 26 cm. The material of the

pot or pan must be steel, enamelled

cast iron or magnetic stainless

steel. If your cookware is alu-

minium, copper, glass, ceramic or

non-magnetic stainless steel, it will

not heat up.

You can easily check this by investigat-

ing whether a magnet will adhere to

your cookware. If it does, you can go

ahead.

CLEANING AND MAINTENANCE

Before cleaning, remove the plug from

the socket and wait until the appliance

has cooled down:

• Use a non-abrasive, non-caustic

cleaning agent and a damp cloth.

Ensure that no water can get into

the appliance.

• Do not immerse the appliance in

water or other liquids.

• Do not use any cleaning products

containing benzene, which can

damage the plastic parts of the

housing.

• Do not use inflammable or alkaline

materials near the appliance. This

can reduce the lifetime of the appli-

ance.

• Avoid using a pan with a base

which could scratch the cooking

surface. Although this will not affect

the operation of your appliance, it

will damage its finish.

• Use a vacuum cleaner to remove

dirt from the fan openings.

• To clean the stainless steel surface,

use Barbecook® All Cleaner.

• Ensure that the appliance has been

properly cleaned before storing it in

a dry place.

• Clean the induction hotplate to pre-

vent colour fading or scorch marks.

AFTER USE

Press the ON/OFF switch to switch

off the appliance As soon as you

remove the pan, the appliance goes

into standby mode. After a minute, it

switches itself off.

STORAGE

To get many years of service out

of your barbecue: Always store the

electrical appliance indoors when not

in use. Cover the barbecue with the

barbecook® cover if it is to be stored

outdoors.

Special precautionary measures for the

stainless steel parts

(failing to follow these instructions will

invalidate the warranty)

When cleaning stainless steel or

chromed parts, it is best to avoid ag-

gressive, abrasive or metal cleaners.

Use non-aggressive cleaners and give

them time to act. Always use always a

soft sponge or cloth. Rinse thoroughly

and dry well before you store the appli-

ance.

To prevent the formation of rust on

stainless steel components, avoid any

contact with chlorine, salt or iron. The

environment in which your appliance is

used can adversely affect its lifetime.

Less suitable locations include the

coast, near railway lines and the vicinity

of a swimming pool.

GUARANTEE

Your Barbecook® appliance carries a

two-year warranty against all manufac-

turing defects. This guarantee applies

from the date of purchase, provided

that it is used in accordance with these

instructions.

For the guarantee to be valid you must

produce the till receipt and mention the

serial number, which can be found:

• On the Type label on the bottom of

your induction appliance.

• In the manual

• On the packaging

The number begins with an “E” fol-

lowed by 15 figures.

This Barbecook® is not suitable for

commercial use. Wear and tear, rust-

ing, distortion and discolouration of

parts which are directly exposed to

the fire or to intense heat are normal

and will under no circumstances be

regarded as manufacturing defects;

they are the logical result of use. Ac-

cordingly the burners, etc. may display

some rusting over time and it is normal

to replace these parts.

This warranty is limited to the repair

or replacement of parts which develop

defects in normal use.

This warranty shall not apply to

defects due to improper installation,

misuse, alterations to the appliance,

disassembly of the appliance, wear

and tear or poor maintenance.

TROUBLE SHOOTING

Display shows = “---” + audible signal

• The appliance has recognised your

cookware as unsuitable.

o Place appropriate cookware on

the appliance within 15 seconds

and carry on.

o If no appropriate cookware is

recognised within 15 seconds,

the appliance will automatically

switch to standby mode. Switch

the appliance off and start again.

• You have removed the cookware

from the hotplate during use.

o Return the pan within 15 sec-

onds, and the appliance will con-

tinue with the selected program.

o If you do not return the pan with-

in 15 seconds, the appliance will

automatically switch to standby

mode. Switch the appliance off

and start again.

Details of error codes:

E01: Undervoltage (<160 V)

Make sure that the apparatus is con-

nected to a circuit with the required

power, and as the only appliance.

E02: Overvoltage (> 270 V)

The appliance is drawing too much

power from the electrical circuit. Ensure

that the appliance is the only one con-

nected to the circuit. The appliance

must be connected in accordance with

local regulations.

E03: IGBT error message

Contact Barbecook customer services.

The appliance must be repaired by a

recognised specialist.

MAN_BRAHMA_K_INDUCTION_BBC130507_A.indd 22 7/05/13 13:58

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Barbecook BRAHMA K INDUCTION Seite 22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info