BLES, FARMS, PLACES SITUATED CLOSE TO GAS DAMPS OR INFLAMMABLE AND/OR EXPLOSIVE
DUST, ETC.
IMPORTANT! DURING THE ASSEMBLY, COMPLY WITH THE FIRE AND ACCIDENT PREVENTION
REGULATIONS OF THE COUNTRY IN WHICH THE HEATER IS INSTALLED.
IMPOR
TANT! DO NOT use the heater in basements if it is pre-set to run on LPG.
2 - ASSEMBLY
Take all the parts out of their package. Be especially careful with the burner (C: Fig.2).
Check whether the contents of the packages is complete and in compliance with the list below
(Fig.2). Follow the regulations in force when throwing away the packages.
Inspection of the PACKAGES’ contents:
A: Fig.3= bell-shaped cylinder protection and base (FIX)
A1: Fig.3= clock, base and set of two diaphragms for use on LPG, umbraco spanner + instruction
notice (FIX).
B: Fig.4 = parabolic hood (NOMAD and FIX)
B1: Fig.4 = parabolic hood and tubes (SPIDER)
C: Fig.5 = pole + burner and fixing knob for the hood (models NOMAD and FIX)
C1: Fig.5 = flanged support + burner and fixing knob, set of 2 diaphragms, umbraco spanner and
instruction notice (model SPIDER)
IMPORTANT! DO NOT PROCEED WITH THE ASSEMBLY IF ONE OF THE PARTS IS
DAMAGED!
IMPORTANT! In the MOBILE appliances (NOMAD), check whether the supplied hose connection
meets the regulations in force in the country where it will be used, before making the connection.
2.1 STEP-BY-STEP ASSEMBLY type “NOMAD” ( (MOBILE type with LPG cylinder):
IMPORTANT! Before assembling the appliance, check whether its parts are appropriate for use in com-
bination with the gas type and the gas pressure foreseen and whether they meet the regulations in force.
Before assembling the heater, remove the two protection plugs (1: Fig.3A and 5: Fig.5). Make sure
you do not lose them (they serve as protection when the heater needs to be dismantled).
IMPORTANT! In compliance with the regulations of the EC Certification, the “INFRA NOMAD CLAS-
SIC” or “INFRA FIX CLASSIC” label shall be apposed in column C of the identification plate of the
appliance at the inside of the clock that is mounted on the pole + burner (see drawing fig. A2).
1 – Put the "base plate + the structure" on the ground and remove the bell-shaped cylinder protec-
tion (2: Fig.3A) in order to facilitate the next steps of the assembly.
2 – Fix the upper, “adjustable” part of the A-shaped structure (1: Fig.6A and 6B) to the “fixed” part
of the base plate at the desired height (“low" gas cylinder, A: Fig.6 or "high" gas cylinder, B: Fig.6
and Fig. 13), using the 4 nuts and screws supplied together with the structure (2: Fig.6A and 6B).
3 - Put the gas cylinder on the base plate and fasten it by inserting the belt (supplied) in the ope-
nings of the A-shaped structure and by winding it around the handles of the gas cylinder (Fig.7).
60
Barbecook INFRÂ
