Bedienungsanleitung Batavia BT-HG004 7063388 UK (Seite 11 von 48) (Deutsch, Englisch, Holländisch, Französisch)

759824

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

8.5 To install the nozzle:

The nozzles can easily be pushed over the hot

air nozzle. Never touch the nozzles during or

immediately after use of the device. The nozzles

are very hot.

8.6 Rotating handle:

The device has two handle positions (see Fig. C)

Position 1 is suitable for killing weeds and ignit-

ing the BBQ. In position 2, the device can be

used as a hot air gun.

To change the handle position (see Fig. C):

• Press the release button (3).

• Turn the handle (7) to the desired position.

• Make sure that the release button (3) has

been locked again.

9 Option 1: Weed Killer

9.1 Assemble the extension handle:

The extension handle consists of two parts.

Connect both parts and attach the extension

handle to the device. To attach the extension,

place the extension handle in the machine and

turn the extension handle a quarter turn to the

right. Make sure that the extension handle rmly

clicks into position. If using the device as a

weed killer you must use the extension handle.

Hold the weed killer rmly by holding the end of

the extension handle.

9.2 Use:

• Ensure the extension handle is rmly xed

onto the device and that the device is

turned off.

• Turn the device to position 1 (see Fig. C)

• Install the nozzle (9) to destroy weeds.

• Insert the plug into the socket.

• Check to ensure the nozzle is not blocked

before turning the device on.

• Set the temperature to setting II.

• Allow the device about 45 seconds to

warm up.

• To eliminate weeds, hold the nozzle over

the weeds for about 5 seconds. During

these 5 seconds the cell structure of the

weed is destroyed. As a result, the weed

dies within a few days.

• It is not necessary to completely burn the

weeds, 5 seconds is more than sufcient.

• For an efcient treatment the nozzle should

be held around 0 to 5 cm above the

weeds.

• The effects are not visible immediately but

will take a while before they can be seen. It

is more of a long-term effect.

• In the case of very leafy plants, the treat-

ment may have to be repeated several

times at intervals of 1 – 2 weeks.

10 Option 2: Specic weed killer

• Ensure the extension handle is rmly xed

onto the device and that the device is

turned off.

• Turn the device to position 1 (see Fig. C)

• Install the Heat-pin (11) to heat-treat the

weed.

• Insert the plug into the socket.

• Set the temperature switch in position “II”.

• Allow the device about 60 seconds to

warm up.

• Position the heat-pin in the middle of the

weed, and push the pin into the weed, up

to the mark, and retract the heat-pin from

the soil after about 2 seconds.

• The effect of the treatment will not be

immediately obvious as it can take several

7063006-Maxxheat-Basic-MA-1712-21.indb 11 04-01-18 11:05

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Batavia BT-HG004 7063388 UK Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info