758293
11
Zoom out
Zoom in
Vorherige Seite
1/26
Nächste Seite
9
English
3. Make sure that the vehicle has the neg-
ative pole on the ground (see manual of

4. Make sure the device is turned off.
5. Make sure that the ignition key is set to
“OFF/OFF. For keyless systems, make
sure that the ignition is turned off com-
pletely before connecting the mobile
power station.
6. Apply the parking brake or parking
brake of the vehicle. (On vehicles with
manual transmission, set the shift lever
to the neutral position.) On vehicles with
automatic transmission, set the lever to
the “P” position).
7. Plug the starter cable (A) into the corre-
sponding socket (8).
8. For vehicles with the negative pole to
ground, connect the red battery termi-
nal Plus to the positive pole of the vehi-
cle battery.
9. Now connect the black battery terminal
Minus only to a grounded point on the
vehicle (e.g. on the engine, chassis or
other grounded location on the vehicle).
10. Turn on the device with the ON/OFF
switch (2).
11. Press the start button (3). The device

seconds. The display (6) shows “OK”.
12. If the vehicle battery is so weak that the
pilot light does not illuminate, wait
about 15 minutes before attempting to
start the engine.
13. Now start the engine. The start attempt
must not take longer than 15 seconds.
Take a break of at least one minute after
each start attempt.
14. As soon as the engine starts, switch off
the device with the ON/OFF switch (2).
15. First remove the black battery terminal
Minus and then the red battery terminal
Plus. When removing the battery termi-
nals, make sure that the cables do not
come into contact with rotating parts of
the motor.
16. Remove the starter cable from the
device.
17. After successfully starting the engine,
wait until it runs smoothly.
12. Jump Start – Special Procedure
with negatively earthed Battery
Older vehicles can still have the positive
pole at the mass.
When starting a vehicle with a negatively
earthed battery, follow the
steps 1 – 7 in chapter Jump Start - Stand-
ard Procedure.
8. First connect the black battery terminal
Minus to the negative pole.
9. Now connect the red battery terminal
Plus to the frame of the vehicle.
Then follow the steps 10 – 17, as described
in the chapter Jump Start – Standard
Procedure.
13. Operating the Compressor
The compressor of the device generates
during operation loud noises that can dam-
age the hearing. Wear ear protection while
operation.
1. Unwind the air hose (14) completely and


2. Use an adapter from the adapter set (B).
3. Open the lever (15), insert the valve plug
(16) onto the valve and push the lever
down.
4. Turn on the device with the ON/OFF

decrease) the air pressure, depress and
hold the buttons (9/10) for at least 5
seconds. To increase the air pressure,
press the plus button (10). To decrease
the air pressure, press the minus

5. To turn on the compressor, press the
compressor button (11). The compres-
sor starts audibly and begins to pump.
6. To turn off the compressor, press the
button (11) again.
7. Open the lever and remove the valve

8. If necessary, check the new air pressure

manometer.
11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Batavia BT-JS001 - 7063516 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info