Bedienungsanleitung Bauknecht BAK3 KN8V IN (Seite 8 von 28) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch)

659239

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

Policies, standard documentation and additional product information can be found by:

• Visiting our website docs . bauknecht. eu

•Using QR Code

•Alternatively, contact our After-sales Service (See phone number in the warranty

booklet). When contacting our After-sales Service, please state the codes provided on your

product's identication plate.

XXXXXXXXXXXXXX

Model: xxxXXXXxx

Download the complete Use and Care Guide from docs.bauknecht.eu for more informations about your product

CLEANING AND MAINTENANCE

Make sure that the oven has cooled

down before carrying out any

maintenance or cleaning.

Do not use steam cleaners.

Do not use wire wool, abrasive

scourers or abrasive/corrosive

cleaning agents, as these could

damage the surfaces of the appliance.

Wear protective gloves.

The oven must be disconnected from

the mains before carrying out any kind

of maintenance work.

REMOVING AND REFITTING THE DOOR

To remove the door, open it fully and lower the catches until

they are in the unlock position (1). Close the door as much as you

can (2). Take a rm hold of the door with both hands - do not

hold it by the handle. Simply remove the door (3) by continuing

to close it while pulling it upwards (a) at the same time until it is

released from its seating (b).

1 2

~60°

~15°

Put the door to one side, resting it on a soft surface. Ret the

door by moving it towards the oven, aligning the hooks of the

hinges with their seating and securing the upper part onto its

seating. Lower the door and then open it fully. Lower the catches

into their original position: make sure that you lower them down

completely. Try closing the door and check to make sure that it

lines up with the control panel. If it does not, repeat the steps

above.

CLICK & CLEAN - CLEANING THE GLASS

After removing the door and resting it on a soft surface with the

handle downwards, simultaneously press the two retaining clips

(1) and remove the upper edge of the door by pulling it towards

you (2).

1 2

Lift and rmly hold the inner glass with both hands, remove it

and place it on a soft surface before cleaning it.

To correctly reposition the inner glass, make sure that the “R”

is visible in the right-hand corner and the clear surface (not

printed) is facing up.

First insert the long side of the glass indicated by “R” into the

support seats, then lower it into position.

Ret the upper edge: a click will indicate correct positioning.

Make sure the seal is secure before retting the door.

TROUBLESHOOTING

Problem Possible cause Solution

The oven does not work. Power cut.

Disconnection from the mains.

Check for the presence of mains electrical power and whether

the oven is connected to the electricity supply.

Turn o the oven and restart it to see if the fault persists.

The display shows the

letter “F” followed by a

number.

Software problem. Contact you nearest After-sales Service Centre and state the

letter or number that follows the letter “F”.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bauknecht BAK3 KN8V IN Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Bauknecht BAK3 KN8V IN

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info