Bedienungsanleitung Bauknecht GKEA 2000 (Seite 7 von 9) (Englisch)

506493

Zoom out

Zoom in

Vorherige Seite

1/9

Nächste Seite

1. The appliance is not working.

•

Is there a power failure?

•

Has the main switch been turned on?

•

Has the fuse blown?

•

Is the thermostat setting correct?

•

Was the appliance switched on correctly?

2. Excessive frost forms inside the

appliance.

•

Has the defrost water drain been

repositioned correctly?

•

Is the door shut properly?

3. The yellow, red and green leds do not

light up. Perform the checks for problem

1, and then:

•

Contact After Sales Service.

Notes:

• The front edge of the appliance may be

hot. This prevents the formation of

condensation and is not a defect.

• Gurgling and hissing noises due to

expansion in the refrigerant circuit are

normal.

Before contacting After-Sales Service:

See if you can solve the problem yourself

with the help of the Trouble-shooting guide.

Switch the appliance on again to see if the

problem has been solved. If it has not,

disconnect the appliance from the power

supply and wait for about an hour before

switching on again.

If the problem persists after this course of

action, contact After-sales Service.

Specify:

•

the nature of the problem,

•

the model,

•

the Service number (the number after the

word SERVICE on the data plate on the

inside of the appliance),

•

your full address,

•

your telephone number and area code.

Note:

The direction of door opening can be

changed. If this operation is performed by

After-sales Service it is not covered by the

warranty.

•

Install the appliance away from heat sources.

Installation in a hot environment, direct

exposure to the sun or installation near heat

sources (heaters, radiators, cookers) will

increase power consumption and should

therefore be avoided.

•

If this is not possible, the following minimum

distances must be respected:

•

30 cm from coal or paraffin stoves;

•

3 cm from electric and/or gas stoves.

•

Install the refrigerator in a dry, well-ventilated

place.

•

Clean the interior (see “How to clean and

defrost the freezer”).

•

Fit the accessories.

Electrical connection

• Electrical connections must be made in

accordance with local regulations.

•

Voltage and power consumption are

indicated on the rating plate inside the

appliance.

•

Regulations

require that the appliance is

earthed.

The manufacturer declines all liability for

injury to persons or animals and for

damage to property resulting from failure

to observe the above procedures and

reminders.

•

If the plug and socket are not of the same

type, have the socket replaced by a qualified

electrician.

•

Do not use extension leads or adaptors.

Disconnecting the appliance

Electrical disconnection must be possible either

by unplugging the appliance or by means of a

double-pole switch located upline from the

socket.

TROUBLESHOOTING GUIDE

AFTER-SALES SERVICE

INSTALLATION

40046cGb.fm5 Page 17 Wednesday, November 29, 2000 1:02 PM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bauknecht GKEA 2000 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Bauknecht GKEA 2000

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info