NLFGBD
GB
Fault indicators
Indicator lights
Off
Blinking
On
The water stop device has been activated
Switch off the appliance and contact After-Sales Service.
The dishwasher has filled with too much water
Reset and start the programme again from the beginning. If the problem
persists, contact After-Sales Service.
Water heating system
Reset and start the programme again from the beginning. If the problem
persists, contact After-Sales Service.
Water heating fault
Reset and start the programme again from the beginning. If the problem
persists, contact After-Sales Service.
The dishwasher does not fill with water
Check the water supply and filters, and make sure that there are no
kinks in the water inlet hose. Open and close the door in order to
continue.
Water does not drain from the dishwasher
Make sure that the filter unit and drain hose are not clogged and if
necessary clean them.
Turbine fault (if present)
Reset and start the programme again from the beginning. If the problem
persists, contact After-Sales Service.
Turbine fault (if present)
Reset and start the programme again from the beginning. If the problem
persists, contact After-Sales Service.
Water filling system fault
Switch off the dishwasher and contact After-Sales Service.
