Bedienungsanleitung Bauknecht GSF 5476 TW-WS (Seite 3 von 4) (Englisch)

457383

Zoom out

Zoom in

Vorherige Seite

1/4

Nächste Seite

Tips and advice

• Arrange crockery so that items do not

touch each other. Arrange large

crockery in the lower rack and smaller

crockery in the upper rack.

• Load cups at an angle to facilitate

water drainage.

• Generally speaking, place cutlery in the

basket with the handles positioned

downwards, but ensure that any sharp

knives and forks that might cause

injury are placed in the basket with the

handles positioned upwards.

• Make sure the water jet can reach all

loaded items and that the spray arms

turn freely.

Important

• Fill the detergent dispenser and check

the salt and rinse aid level.

• Do not use the appliance for items not

suitable for washing in a dishwasher,

for example: wooden items, aluminium,

plastic utensils, tin, hand-decorated

crockery (unglazed), silver cutlery.

• Do not put liquid fat in the dishwasher

(e.g. oil used for frying) or candle wax.

• If a fault occurs or you wish to change

the current programme, press the

“START” button for about 5 seconds

until the Start indicator lamp switches

off.

• If regeneration salt is to be added,

immediately

start a wash programme

in order to eliminate any residual salt

(rinsing alone is not sufficient).

• Sometimes even though the

regeneration salt container has been

filled, the corresponding indicator lamp

(if fitted) will light up during the first

wash cycle after filling with salt.

• Before starting a wash programme,

make sure that the spray arms can turn

freely and are not impeded by crockery

or cutlery.

• Only switch off the dishwasher once the

“Start” indicator lamp has switched off.

If the dishwasher is switched off during

a wash cycle, when switched on again it

will resume the cycle from where it was

interrupted without having to start it

again.

If a fault occurs, before contacting our

After-Sales Service, make the following

checks to try and remedy the problem:

The dishwasher is not working:

• Is the plug properly inserted in the wall

socket?

• Is there a power failure?

• Is the dishwasher switched on?

• Has the Start button been pressed?

• Has the delayed start timer been set (if

fitted)?

• Is the water supply tap on?

• Is the flow of water obstructed by

impurities? If so, close the water supply

tap, detach the water hose and clean the

filter. Then re-connect the water hose to

the tap and open the water tap once

again.

• Are the filters clogged? (See “Care and

maintenance” chapter in the user

instructions).

• Is the door closed properly?

• Is a fault indicated?

(The Start indicator lamp flashes).

Start the programme again from the

beginning: press the Start button for

about 5 seconds, until the Start indicator

lamp switches off.

Select a new programme and press the

Start button.

Crockery still dirty after washing:

• Was the crockery loaded properly?

• Crockery must be loaded facing

downwards; this is important, especially

for large items of crockery.

• The water jets must spray the entire

surface of all items.

• Make sure that crockery and cutlery are

arranged properly.

• Have you selected the correct programme?

• Did you use too much or too little detergent?

(The use of poor quality detergents may

result in less effective washing).

• Are the filters clogged or incorrectly

assembled? (See “Care and

Maintenance” chapter in the user

instructions).

• Are the spray arms blocked or the nozzles

clogged? (See “Care and Maintenance”

chapter in the user instructions).

• Is the lower spray arm correctly fitted?

• Is the salt container cap (water softening

system) screwed down?

Marked crockery:

• Is the water hardness level selector not

properly adjusted? See (“Filling the salt

container” in the user instructions).

• Is the salt container empty? (See “Filling

the salt container” in the user

instructions).

• Was insufficient detergent used? (See

“Filling the detergent dispenser” in the

user instructions).

Marked glasses and cutlery:

• Was too much rinse aid used? (See

“Filling the rinse aid dispenser” in the user

instructions).

Note:

with some models, when the Start button

is pressed a pre-wash cycle precedes the

actual wash programme; this regenerates the

water softening system.

If after carrying out the above checks the

malfunction persists or appears again,

turn the appliance off and turn off the

water supply tap, then call our After-Sales

Service (see guarantee). Please specify:

• The nature of the fault.

• The appliance type and model.

• The service code (the number after the

word Service on the adhesive rating plate)

inside the door on the right-hand side.

•

Your full address and telephone number.

AFTER-SALES

SERVICE

Troubleshooting Guide

Please read the user instructions carefully.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bauknecht GSF 5476 TW-WS Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Bauknecht GSF 5476 TW-WS

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info