Bedienungsanleitung Bauknecht KMT11 F45 (Seite 16 von 36) (Englisch)

793482

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

appliance is pressed down ( g. 2);

2. SELECT LANGUAGE : press (B10) or (B8) until the

 ag corresponding to the required language appears on the

display (B), then press the  ag;

Follow the instructions indicated on the appliance display:

1. FILL TANK WITH FRESH WATER : remove the water tank

(A12) ( g. 3), open the lid ( g. 4),  ll to the MAX line

(marked on the inside of the tank) with drinking water ( g.

5), close the lid and put the tank back in the appliance ( g.

6);

2. INSERT WATER SPOUT : Check that the hot water/steam

spout (C4) is inserted on the connection nozzle (A10) ( g.

7) and place a container holding a minimum of 100 ml un-

derneath ( g. 8);

3. WATER CIRCUIT EMPTY PRESS OK TO START FILLING PRO-

CESS appears on the display;

4. Press to con rm. The appliance delivers water

from the spout ( g. 8) then goes o automatically.

The co ee machine is now ready for normal use.

• The  rst time you use the appliance, you need to make 4-5

cappuccinos before it starts to give satisfactory results.

• The  rst time you use the machine, the water circuit is emp-

ty and the appliance could be very noisy. The noise becomes

less as the circuit  lls.

• When making the  rst 5-6 cappuccinos, it is normal to hear

the noise of boiling water. After this, the noise becomes

less.

TURNING THE APPLIANCE ON

Before turning the appliance on, make sure the main switch

(A19) is pressed ( g. 2). Each time the appliance is turned on, it

performs an automatic preheat and rinse cycle which cannot be

interrupted. The appliance is ready for use only after completion

of this cycle.

WARNING

During rinsing, a little hot water comes out of the co ee spouts

(A13) and is collected in the drip tray (A14) underneath. Avoid

contact with splashes of water.

• To turn the appliance on, press the button (A7  g.

9). The message HEATING UP UNDERWAY PLEASE WAIT ap-

pears on the display.

• When heating is complete, the message changes to: RINS

ING UNDERWAY, HOT WATER FROM SPOUTS. As well as

heating the boiler, this also heats the internal circuits by

circulating hot water.

The appliance is at temperature when the main screen (home-

page) appears.

TURNING THE APPLIANCE OFF

Whenever the co ee machine is turned o after being used to

make co ee, it performs an automatic rinse cycle.

WARNING

During rinsing, a little hot water  ows from the co ee spouts

(A13). Avoid contact with splashes of water.

• To turn the appliance o , press the button (A7-

 g.9).

• The message TURNING OFF UNDERWAY, PLEASE WAIT is

displayed, then (if applicable) the appliance performs a

rinse cycle and goes o (standby).

If you will not be using the appliance for some time,  rst empty

the water circuit (see section “Emptying the circuit”), then un-

plug from the mains socket as follows:

•  rst turn the appliance o by pressing the button;

• release the main switch (A19) at the side of the appliance

( g. 2).

Do not press the main switch while the appliance is on.

MENU SETTINGS

Rinsing

Use this function to deliver hot water from the co ee spouts

(A13), to clean and heat the appliance’s internal circuit. Place a

container with a minimum capacity of 100ml under the co ee

and hot water spouts ( g. 8).

To enable the function, proceed as follows:

1. Press (B2) to enter the menu;

2. Press (B10) or (B8) until RINSING appears on

the display (B);

3. Press

the display (B);

to start rinsing.

WARNING

Do not leave the appliance unattended while hot water is being

delivered.

1. After a few seconds, hot water is delivered from the co ee

spouts, to clean and heat the appliance’s internal circuit.

RINSING UNDERWAY, HOT WATER FROM SPOUTS appears on

the display, together with a progress bar which  lls gradu-

ally as preparation proceeds;

2. To stop rinsing, press or wait for rinsing to stop

automatically.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bauknecht KMT11 F45 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Bauknecht KMT11 F45

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info