Bedienungsanleitung Bauknecht trak 6460 (Seite 2 von 2) (Englisch)

301826

Zoom out

Zoom in

Vorherige Seite

1/2

Nächste Seite

5019 407 00115

1. Check that all fastenings are closed and

that pockets are empty.

2. Turn the articles inside out.

3. Place laundry loosely in the drum to make

sure it doesn’t become tangled.

Sort laundry as follows:

A) By care symbols

(on the collar or inside seam):

Suitable for tumble drying

Tumble drying with reduced

drying intensity only. Press gentle

button

Do not tumble dry

B) By amount and thickness/weight

Whenever the load to be dried exceeds

dryer capacity, separate laundry

according to weight (e.g. towels from

thin underwear).

C) By type of fabrics

Cotton/linen

: towels, cotton jersey, bed

and table linen made of cotton or linen.

Synthetics/Easy Care

: blouses, shirts,

overalls, etc. made of polyester or

polyamide, as well as cotton/synthetic

mixes.

D) By drying level

• Sort into: iron dry, cupboard dry, etc.

Do not tumble dry:

woollens, silk, nylon

stockings, delicate embroidery, fabrics with

metallic decorations, bulky items such as

sleeping bags, etc.

Important: only use specific indicated

dryer-safe additives

and rinse items that

have been treated with stain remover

thoroughly in plenty of water before drying.

Only use specific indicated dryer-safe

plastic items

and

never

dry rubber or

articles contaminated with vegetable oil in

the dryer

(Option only available when

Programme is selected).

Push the button to turn the drum light on for

30 sec. and push again to turn the drum light

off.

Programme and Options:

• To select a programme, turn the

programme selector knob. The Start/

Pause indicator lamp is blinking,

indicating that the cycle needs to be

started.

• To select an option, press the

corresponding button. The indicator

lamp above the button confirms that a

selection has been made.

• Press the button again to cancel the

option.

1. Having selected the desired programme

and options, press the Start button.

If the laundry is not removed at the end

of the drying cycle, an automatic anti-

crease cycle will operate for maximum

60 min. The drum rotates at regular

intervals, preventing the laundry from

creasing.

Anti-Crease protection re-

distributes laundry in the drum.

When the Anti-Crease option is selected

and laundry has not been taken out, an

anti-crease cycle is activated for 12 hrs.

2. On completion of the programme, set the

programme selector knob to position

“0”

When changing the programme during the

drying cycle, the dryer stops. The Start/Pause

indicator lamp is blinking.

To operate the new programme, press the

Start/Pause button again.

To interrupt the dryer during operation

1. Set the programme selector knob to

Airing.

2. Press the Start button.

Wait at least 5 minutes before opening

the door to allow the dryer to cool

down.

For your safety the programme stops

automatically if you open the door.

3. To restart, after door opening, close the

door and press the Start/Pause button

again.

Clean the lint filter at the end of every

drying cycle:

1. Open the door.

2. Pull the filter upwards.

3. Remove lint using a soft brush or your

fingertips.

4. Push the filter back into place.

If a fault occurs, before contacting our After-

Sales Service, make the following checks to

try and remedy the problem:

Drying takes too long / laundry is not

dry enough:

• Was the correct programme selected?

• Was the inserted laundry too wet

(Washing machine spin speed less than

800 rpm)?

• Is the lint filter dirty (filter indicator lamp

on)?

The dryer does not operate:

(after a power failure and/or

interruption to the mains supply,

always press the Start button).

• Is the plug properly inserted into the

mains electricity socket?

• Is there a power failure?

• Has the fuse blown?

• Is the door well closed?

• Has the programme been selected?

• Has the start-delay option been selected?

• Has the

Start/Pause

button been

pressed?

Lint filter indicator lamp on:

• Is the lint filter clean?

• Is the vent hose blocked?

All programme sequence indicators

blinking:

• Service call necessary.

Replacing the drum light bulb (if supplied):

• If the inside lamp does not work, the bulb

may be faulty.

• Unplug the dryer.

• Open the door and unscrew the glass

cover insie the drum.

• Replace the faulty bulb with a new one

and screw the glass cover back on.

• Replacement bulb: Philips 15W,

230/240V, E14.

If, after carrying out the above checks the

malfunction persists or appears again, turn

the dryer off and call our After-Sales Service

(refer to guarantee).

Please specify:

• The nature of the fault.

• The dryer type and model.

• The service code (the number after the

word Service on the adhesive rating

plate) on the right-hand side when the

door is open.

• Your full address and phone number.

PREPARING THE LAUNDRY

DRUM LIGHT OPTION

SELECTING A PROGRAMME & OPTIONS

STARTING & COMPLETING A

PROGRAMME

CHANGING A PROGRAMME

INTERRUPTING A PROGRAMME

DAILY MAINTENANCE & CLEANING

TROUBLESHOOTING GUIDE

AFTER-SALES SERVICE

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bauknecht trak 6460 Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Bauknecht trak 6460

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info