Bedienungsanleitung Bauknecht trkk 6621 (Seite 2 von 2) (Englisch)

303239

Zoom out

Zoom in

Vorherige Seite

1/2

Nächste Seite

5019 407 00234

1. Check that all fastenings are closed and

that pockets are empty.

2. Turn the articles inside out.

3. Place laundry loosely in the drum to

make sure it doesn’t become tangled.

Sort laundry as follows:

A) By care symbols (on the collar or

inside seam):

Suitable for tumble drying

Tumble drying with reduced

drying intensity only. Press

Gentle button.

Do not tumble dry

B) By amount and thickness/weight

Whenever the load to be dried exceeds

dryer capacity, separate laundry

according to weight (e.g. towels from

thin underwear).

C) By type of fabrics

Cotton/linen: Towels, cotton jersey,

bed and table linen made of cotton or

linen.

Synthetics/Easy Care: Blouses, shirts,

overalls, etc. made of polyester or

polyamide, as well as cotton/synthetic

mixes.

D) By drying level

• Sort into: iron dry, cupboard dry, etc.

Do not tumble dry: Woollens, silk, nylon

stockings, delicate embroidery, fabrics

with metallic decorations, bulky items such

as sleeping bags, etc.

Important: only use specific indicated

dryer-safe additives and rinse items

that have been treated with stain remover

thoroughly in plenty of water before

drying. Only use specific indicated

dryer-safe plastic items and never dry

rubber or articles contaminated with

vegetable oil in the dryer.

Programme and Options:

• To select a programme, turn the

programme selector knob to the

required position. The start indicator

lamp is blinking, indicating that the

cycle needs to be started.

• To select an option, press the

corresponding button. The indicator

light in the button lights up confirming

that the selection has been made.

• Press the option button again to cancel

the option.

1. Having selected the desired

programme and options, press the

Start/Pause button.

As soon as the drying cycle is finished

the END indicator lamp is lit and the

laundry can be removed.

If the laundry is not removed at the

end of the drying cycle, an automatic

anti-crease cycle will operate for

maximum 60 min. The drum rotates at

regular intervals, preventing the

laundry from creasing.

Anti-Crease protection re-distributes

laundry in the drum.

2. On completion of the programme, set

the programme selector knob to

position “0”.

When changing the programme during

the drying cycle, the dryer stops. The start

indicator lamp is blinking.

To operate the new programme, press the

Start/Pause button.

To interrupt the dryer during operation

1. Set the programme selector knob to

Airing.

2. Press the Start/Pause button.

Wait at least 5 minutes before opening

the door to allow the dryer to cool down.

For your safety the programme stops

automatically if you open the door.

3. To restart, after door opening, close

the door and press the Start/Pause

button again.

Clean the lint filter at the end of every

drying cycle:

1. Open the door.

2. Pull the filter upwards.

3. Open the filter.

4. Remove lint using a soft brush or your

fingertips.

5. Close the filter.

6. Push the filter back into place.

Empty the water container at the end

of every drying cycle.

1. Pull the handle to remove the water

container.

2. Empty the water container.

3. Replace the water container when

empty by pushing it completely

back

in place.

If a fault occurs, before contacting our

After-Sales Service, make the

following checks to try and remedy

the problem:

Drying takes too long / laundry is not dry

enough:

• Was the correct programme selected?

• Was the inserted laundry too wet

(Washing machine spin speed less than

800 rpm? When the spinning speed is

less than 800 rpm the water container

fault may occur during the drying

cycle.)?

• Is the lint filter dirty (filter indicator lamp

on)?

• Is the heat exchanger dirty? (refer to

the Instructions for use)

• Is the ambient temperature too high?

The dryer does not operate:

(after a power failure and/or

interruption to the mains supply,

always press the Start/Pause button).

• Is the plug properly inserted into the

mains electricity socket?

• Is there a power failure?

• Has the fuse blown?

• Is the door properly closed?

• Has the programme been selected?

• Has the Start/Pause button been

pressed?

Lint filter or water container indicator

lamp light on:

• Is the lint filter clean?

• Is the water container empty?

• Is the water container correctly

positioned?

• Is the heat exchanger clean?

Water droplets underneath the dryer:

• Is the heat exchanger correctly

positioned?

• Has any fluff on the heat exchanger

seal been wiped away?

• Has any fluff on the door seal been wiped

away?

• Has the water container been

positioned correctly?

If, after carrying out the above checks the

malfunction persists or appears again, turn

the dryer off and call our After-Sales

Service (refer to guarantee).

Please specify:

• The nature of the fault.

• The dryer type and model.

• The service code (the number after the

word Service on the adhesive rating

plate) on the right-hand side when the

door is open.

• Your full address and phone number.

PREPARING THE LAUNDRY SELECTING A PROGRAMME & OPTIONS

STARTING & COMPLETING A

PROGRAMME

CHANGING A PROGRAMME

INTERRUPTING A PROGRAMME

DAILY MAINTENANCE & CLEANING

TROUBLESHOOTING GUIDE

AFTER-SALES SERVICE

Bauknecht trkk 6621 Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Bauknecht trkk 6621

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info