Bedienungsanleitung Bauknecht trkp 6960 (Seite 2 von 8) (Englisch)

302621

Zoom out

Zoom in

Vorherige Seite

1/8

Nächste Seite

Before Using the Dryer / Connections

1. Removing the

packaging and check



After unpacking, make sure

that the dryer is undamaged.

If in doubt, do not use the

dryer. Contact After-Sales

Service or your local retailer.



Keep the packaging materials

(plastic bags, polystyrene

parts, etc.) out of reach of

children, as they are

potentially dangerous.



Remove the protective foil

from the control panel.

2. Electrical Connections



Electrical connections must be

carried out by a qualified

technician in compliance with

the manufacturer's

instructions and current

standard safety regulations.



Electrical connection must

comply with local Electricity

Board regulations.



Voltage information, power

consumption and the required

fuse protection is shown on the

rating plate mounted at the

rear of the dryer.



The manufacturer cannot

accept any liability for

personal injury or damage to

property resulting from

failure to adhere to these

instructions.



The dryer must be earthed as

prescribed by law.



Do not use extension leads or

multiple adaptors.



Before any maintenance on

the dryer disconnect it from

the mains supply.



Do not operate the dryer if it

has been damaged during

transport. Contact one of our

After-Sales Service

technicians.



Mains cables must be

replaced by an original cable

and is only to be carried out

by a technician from After-

Sales Service or an authorized

electrician.



After installation access to

the mains plug has to be

guaranteed, or the all-pole

disconnection has to be

possible with a switch.

3. Installation



Do not install your dryer

where it can be subject to

extreme conditions, such as:

poor ventilation,

temperatures around

freezing or above 35° C.



Before running the first cycle

ensure the water container

and heat exchanger are

correctly positioned.



Only for water container top

version: if possible use the

hose supplied to drain the

water directly into the

domestic plumbing system.

This will avoid having to

empty the water container at

the end of each drying cycle

since the condensation water

can be directly drained away.



Take care not to install the

dryer on a deep-pile carpet.



Take care not to trap the

mains cable between the

dryer and the wall.

Stability:

When installing the dryer

always carefully level the

dryer adjusting the four feet

and check the correct

levelling with a spirit level.

To built in the dryer

Remove the work-top and

replace it with the Built-In kit

UBS 10 (according to Eec

Electrical Regulations), which

can be ordered at your

dealer.

Stacking kit

Your dryer can be stacked on

top of your front loading

washing machine. To do this,

use stacking kit AMH 752,

available at your dealer.

Minimum housing

dimensions:

Width: 600 mm

Height: 850 mm

Depth: 600 mm

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bauknecht trkp 6960 Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Bauknecht trkp 6960

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info