Bedienungsanleitung Bauknecht WA 89880 (Seite 3 von 23) (Englisch)

572348

Zoom out

Zoom in

Vorherige Seite

1/23

Nächste Seite

5019 401 15073

Add the detergent as described in the chapter

“Detergent and Additives” in the booklet.

1. Turn the programme selector knob in

any direction to the desired programme.

The remaining time display shows the

duration of the chosen programme

(in hours and minutes) and the pilot lamp

above the “Start/Pause” button is

flashing.

2. The programme sequence indicator and

the indicator with the maximum possible

spin speed light up.

3. The temperature can be altered by pressing

the “+” or “-” button under the

corresponding LED display.

“Prewash” button

• Only for heavily soiled laundry (for

example sand or granular dirt).

Programme duration is increased by some

15 min.

“Intensive Rinse” button

• An additional rinse cycle is carried out.

• This additional option is particularly

suitable for areas with very soft water, for

washing baby linen and helping people

with detergent allergies.

“Rinse Hold” button

• The laundry remains in the last rinse

water without being spun: discoloration

of the laundry and additional creasing are

prevented.

• This additional option is particularly

recommended for the programme

“Synthetics” or “Delicates”.

• This additional function is particularly

useful if you want to postpone spinning

to a later time.

Note: the programme has reached the “Rinse

Hold” when the “Rinse Hold” button light flashes.

Terminate the “Rinse Hold” option:

• Press the “Rinse Hold” button again; the

programme will terminate automatically

with the appropriate spin cycle for the

current programme.

• If you do not wish to spin the clothes, turn

the programme selector knob to

“Draining/Clearing” and press the “Start/

Pause” button again.

“Speed Reduction” button

• A maximum spin speed is assigned to each

programme.

• Press the button to set another speed for

the spin cycle.

CONSUMPTION DATA

Programme Temperature

(°C)

Load

(kg)

Water

(l)

Energy

(kWh)

Programme duration **

approx.

(hours : minutes)

White Cotton 95 5,0 44*** 1,60 1:55

Coloured cotton 60 5,0 39 0,95 2:00

Coloured cotton 40 5,0 39 0,55 2:00

Synthetics 60 2,5 55 0,70 1:30

Synthetics 40 2,5 50 0,50 1:15

Rapid wash 30 3,0 35 0,40 0:30

Delicate 30 1,5 50 0,50 0:45

Wool 40 1,0 50 0,50 0:40

Handwash 30 1,0 35 0,40 0:35

* Consumption values were measured in normalized conditions in compliance with Standard IEC 60456.

** The programme duration may also vary from the chart values. The washing machine is able to allow for

particular household conditions and to adapt the programme run time accordingly.

*** To reduce the water temperature, some cold water is added at the end of the main wash cycle, before

the pump drains the water out.

POUR IN DETERGENT, CLOSE THE

DOOR AND SELECT A PROGRAMME

SELECT SPECIAL OPTIONS - The

indicator lights go on.

• If the spin speed “0” is selected, the final

spin is cancelled. The water is drained out

only.

“Easy Ironing” button

• To lessen creasing, the water quantity is

increased and the clothes are spun very

gently at reduced power. This makes your

laundry significantly damper at the end of

the programme.

“Eco Wash” button

• The duration of the wash is extended and

the temperature reduced. This saves you

up to 30% energy and maintains good

washing results.

The “Start Delay” allows to run the machine

at the consumer’s convenience, for example

at night when electricity is cheaper.

• Press the “Start Delay” button. Select the

programme start from 1 to 19 hours

ahead by pressing the button again.

• Press the “Start/Pause” button. The

Start Delay indicator light flashes until the

programme starts.

• During programme start the remaining

time appears in the digital display.

“Start Delay” correction.

• Before the “Start Delay” has been started:

The preset number of hours can be

altered by continuously pressing the

“Start Delay” button.

The number of hours can be reduced by

first turning the programme selector

switch to the “Off” position. Then set the

programme again and select the desired

number of hours.

• After the “Start Delay” has been started:

The preset number of hours can be reduced

by pressing the “Start Delay” button again.

To increase the number of hours

preselected, first turn the programme

selector switch to the “Off” position. Then

set the programme and the additional

options again and select the desired

number of hours.

After you have selected the programme and

the additional option, the indicator light

over the “Start/Pause” button flashes. Turn

on the tap and start the programme by

pressing the “Start/Pause” button. Now the

indicator light above the button goes on.

In addition, all programme phases are

indicated by the associated lights. After the

end of a programme phase the associated

indicator light goes out. Thus the

programme sequence indicator moves from

left to right across the wash, rinse and spin

phases. At the end of the programme only

the “End” indicator is still on.

In the first 15 minutes after the start of the

“Cotton”, “Coloured Cotton” and

“Synthetic” programmes the door can be

opened to add further laundry. This is not

possible if “Rapid Wash” is selected.

• The remaining time display shows “0:00”

and the “End” display lights up.

1. Turn the programme selector knob to the

“Off” position.

2. Turn off the tap.

3. Open the door and unload the machine.

A newly-selected programme will continue

in the same programme section during

which the current programme was

interrupted. Therefore do not add any more

detergent.

1. Press the “Start/Pause” button to

interrupt the programme. The indicator

light flashes.

2. Select the new programme (with

temperature), any additional options and

- if you wish - another spin speed.

3. Press the “Start/Pause” button again to

restart the programme.

• If you are in the “Prewash” programme

step this additional option can not be

deselected as described (to do this see

“Interrupt/Cancel Programme).

1. Press the “Start/Pause” button to

interrupt the programme. The indicator

light flashes.

2. Set the programme selector to “Draining/

Clearing”. The spin speed “0” and the

remaining time “2 minutes” are displayed.

3. Press the “Start/Pause” button to start

the “Draining/Clearing” programme.

START DELAY

PROGRAMME START

DOOR LOCK

PROGRAMME END

RESELECT AFTER PROGRAMME START

CANCEL/DELETE PROGRAMME

Bauknecht WA 89880 Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Bauknecht WA 89880

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info