ON / OFF
DMX mode ON / OFF
Pause/Start auto program or sound program
Sound program S1
Sound program S2
Sound program S3
Strobe ON/ OFF
Auto program, chose A1, A2, A3, A4, A5, A6, A7
Increase or decrease speed
The remote control is supplied with a battery inserted. An insulating
foil between the battery and the battery contacts prevents the battery from being
discharged during storage. Prior to the first operation remove the foil from the
battery support on the rear side of the remote control. Otherwise operation of the remote
control is not possible.
For operation, one 3 V button cell type CR 2025 is required. When inserting, pay attention
that the positive pole of the button cell shows upwards in the support.
The buildup of dust, dirt and other airborne particles will reduce the unit’s light output. It will also prevent the unit from cooling correctly, and this will
reduce the unit’s lifetime. The rate of dirt buildup will vary depending on environmental factors such as airborne dust, use of smoke machines, airflow
from ventilation systems, etc. The unit’s cooling fans will accelerate buildup, and any smoke particles that are present in the atmosphere will increase the
tendency for dirt to clog.
To get the best performance and lifetime from the unit, inspect it regularly and clean it as soon as you see signs of dirt buildup.
Assess the operating environment each time you begin to use the unit. In dusty or smoky conditions, inspect the unit after a few hours and check it
frequently the unit may attract dirt faster than you expect. Draw up a cleaning schedule that will make sure that dirt is removed before it can build up.
Use the following guidelines:
• Disconnect the unit from power and allow it to cool completely before cleaning.
• Do not use solvents, abrasives or any other aggressive product to clean the unit.
• Vacuum or use low-pressure compressed air to remove dust and loose particles from surfaces and air vents. Prevent the blades of cooling fans
from turning before you aim a vacuum or air jet at the fan, or you may spin the fan too fast and damage it.
• Clean glass components by wiping gently with a soft, clean, lint-free cloth moistened with a weak detergent solution. Put the solution on the cloth
and not on the surface to be cleaned. Avoid rubbing glass surfaces.
• Dry the unit with a soft, clean, lint-free cloth or low-pressure compressed air before reapplying power.
