Location
Select a location where it is easy to fill the tank. It is also possible to hang the unit by means of the supplied holder and
fixing screws.
Switching the unit off
Switch the unit off by unplugging it from the mains. Otherwise the 1800W heating element will draw unnecessarily current.
Settings
Press the MENU button on the remote control to select the various functions . Press the UP and DOWN buttons to
set the various functions . After 10 seconds, the settings are automatically transferred and the unit is ready for use.
- Man Vol Out: amount of smoke in % , when using the LOCK button on the remote
- Set Interval : the time between the outputs in seconds , using the TIMER function on the remote
- Set Duration : the length of the outputs in seconds , using the TIMER function on the remote
- Volume Out: no function with this machine
- DMX512 # 000-512 : Start Address when using a DMX controller
DMX operation
Connect the machine directly to a DMX controller or DMX DMX loop with multiple effects. The machine uses a
3-pin XLR connector for DMX connection.
Address Setup: Press the MODE button several times until DMX512 # ... is displayed, use the UP / DOWN buttons
to set the start address. The start address is defined as a first channel to which the machine will respond. Verify that
there are no overlapping channels used!
Note: It is necessary to always finish with a 120 Ohm termination plug for proper data transmission DMX loop..
Maintenance
Refilling the fluid reservoir should be done carefully. Remove the plug from the mains first! Then unscrew the cap of the
reservoir and fill it by means of a suitable funnel. Use only the original Beamz smoke liquid. This fluid is environmentally
friendly, biodegradable and leaves no residue when used correctly. Make sure the smoke liquid to become contaminated,
close the cap of the liquid smoke can and after filling tank right.
After 40 hours, the smoke machine must be cleaned to avoid deposits in the machine, pump and heater.
Clean procedure: Run clean procedure in a well-ventilated area
• Remove smoke liquid from the tank, add cleaning solution to tank
• Switch smoke machine and wait until it is warm up
• Press the button to switch the liquid pumped through the machine
• Perform the above operation until the tank is empty
• Fill the tank with liquid smoke
