Bedienungsanleitung Bebe Confort Titan Plus (Seite 49 von 84) (Englisch, Französisch, Italienisch, Portugiesisch, Spanisch)

768766

Zoom out

Zoom in

Vorherige Seite

1/84

Nächste Seite

Bébé Confort I Titan Plus I 49

of the system, the user is advised to contact the

distributor or the manufacturer of the child restraining

device system.

• When installing the car seat for group 1 with ISOFIX,

it is necessary to remove the headrest in order to put

the TOP TETHER through correctly.

Your child in the Bébé Confort Titan Plus

• Make sure you can ﬁt no more than one ﬁnger

between the harnesses and your child (1cm). If there is

more space than 1 cm, tighten the harness belt further.

• Make sure the headrest is adjusted to the proper

height.

Care

Inlay:

• The inlay included in your Bébé Confort Titan Plus

seat plays an integral part in the eciency of the

restraint system for your child from 9 to 13 kg. It can

be removed and the cover taken o for washing, but

it is essential to place it back again where it belongs

and only use this ocial Bébé Confort Titan Plus inlay.

This inlay is exclusively for use with the Bébé Confort

Titan Plus seat.

Fabric:

• The cover and crotch pad can be removed for

washing.

If the cover needs to be replaced at any time, only use

ocial Bébé Confort cover because it constitutes an

integral part of the restraint performance.

• For safety reasons, shoulder pads are not removable.

Clean it by using a damp cloth.

Notice

This is a “Universal” child restraint. It is approved to

Regulation No. 44, 04 series of amendments, for

general use in vehicles and it will ﬁt most, but not

all, car seats.

A correct ﬁt is likely if the vehicle manufacturer has

declared in the vehicle handbook that the vehicle is

capable of accepting a “Universal” child restraint for

this age group.

This child restraint has been classiﬁed as

“Universal” under more stringent conditions than

those which applied to earlier designs which do not

carry this notice.

If in doubt, consult either the child restraint

manufacturer or the retailer.

Only suitable if the approved vehicles are ﬁtted

with 3 point safety-belts, approved to UN/ECE

Regulation No. 16 or other equivalent standards.

Seat positions in other cars may also be suitable

to accept this Child Restraint. If in doubt, consult

either the Child Restraint manufacturer or the

retailer.

Only suitable if the approved vehicles are ﬁtted

with 3 point safety-belts, approved to UN/ECE

Regulation No. 16 or other equivalent standards.

In forward facing position, the seat must be placed

on the car rear seat or exceptionally on the front

seat in accordance with the legislation in force in

the country of use (In France: in accordance with

the conditions stipulated in decree n°91-1321 du

27-12-1991).

SAFETY

• All products have been carefully designed and

tested for your child’s safety and comfort. Use only

accessories sold or approved by our company. Using

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Bebe Confort Titan Plus Seite 49

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info