Bedienungsanleitung Beefeater 1500 series Mobile (Seite 6 von 32) (Englisch)

810613

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

GAS CYLINDER SAFETY INFORMATION

Gas cylinders must be stored outdoors, out of reach of

children and must not be stored in a building, garage or any

other enclosed area.

• This appliance is designed to be used with a gas cylinder

not exceeding 9kg (20lbs) capacity. The overall size of the

gas bottle should not exceed 315mm in diameter and

460mm in height.

• The Gas cylinder must be constructed and marked in

accordance with specifications for LP Gas Cylinders.

• Ensure gas cylinder is within the expiration date, it is not

advised to use or attempt to refill a gas cylinder that is

outside of it’s expiration date.

• The gas cylinder supply valve must be turned off when

the appliance is not in use.

• The gas cylinder used must incorporate a safety collar to

protect the valve assembly.

• The gas cylinder must always be kept and used in the

upright position.

TIPS & INFORMATION

IMPORTANT

When disconnecting and removing the gas cylinder for

the purpose of refilling, always observe the following

procedure:

• Ensure that all gas control valves on the appliance and

the gas cylinder are turned off before disconnecting the

gas line from the cylinder.

• Do not smoke or use a naked flame near the appliance

or gas cylinder while disconnecting the gas line between

the appliance and gas cylinder.

• Remove the gas cylinder from the enclosure before

disconnecting the gas line from the appliance.

• Tighten all connections before placing the gas cylinder

back in its enclosure.

The Gas Leak Testing Procedure should be conducted every

time the gas cylinder is refilled and reconnected to the

appliance – before using the appliance.

Regulator Connection

1. Check that all control knobs are in the ‘Off’ position.

2. Make sure the cylinder valve is off by turning the valve

knob all the way clockwise.

3. Remove the protective cap from the cylinder if present.

4. Make connection as described in figures 1 and 2.

5. Leak-test the connection with a soapy water solution.

(See Gas Leak Testing Procedure).

Hose and regulator replacement must be a genuine part

specified for this appliance and is obtainable from your

nearest BeefEater stockist.

FIG 1

Standard regulator

FIG 2

Quick connect regulator

Gas Leak Test Procedure

Use the following procedure to check for gas leaks.

Never use a naked flame to check for gas leaks.

1. In a small container, mix up a solution of water and

detergent or soap. Mix the solution well.

2. Make sure that the gas supply valve on the gas cylinder

is turned on.

3. Make sure that the gas control valves on the appliance

are all turned off.

4. Using a brush or spray bottle apply the solution to the

gas line and each join in the gas line.

5. Bubbling of the solution will indicate that there is a leak

present.

6. Re-tighten or re-seal any joints that are leaking.

7. If a leak persists then contact your distributor or the

manufacturer for assistance.

GAS CYLINDER SAFETY INFORMATION

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Beefeater 1500 series Mobile Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Beefeater 1500 series Mobile

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info