Bedienungsanleitung Beefeater Proline Side Burner (Seite 9 von 20) (Englisch)

810610

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

GAS CONVERSION INSTRUCTIONS

GAS BOTTLE SAFETY

LPG SAFETY INFORMATION

5� Adjust primary air shutter (if necessary) by loosening the

adjustment screw and rotating shutter to achieve the

desired gap� Refer to “Primary Airation Gap” as defined

in Gas Specification table on page 6 for recommended

gaps for different gas types

6� Replace Burner and cover panel�

When changing gas types it may be necessary to adjust the

valve to achieve the desired turn down setting� This can only

be completed after the connection to the gas supply and leak

test has been conducted�

Adjust the turndown setting on the valve�

To complete the conversion the turndown setting of the valve

will need to be adjusted, and at the same time the operation

of the appliance can be tested� Proceed as follows:

• Check that the burner ignites (REFER OPERATING

INSTRUCTIONS)�

• Light the burner and rotate the control knob to the

lowest setting, then remove the knob from the valve

shaft, and remove the grommet�

• Using a small flat-blade screwdriver adjust the

turndown adjustment screw to achieve a small steady

flame on the burner�

• Replace the grommet and the knob�

• Recheck the operation of the burner at maximum

and turndown�

LPG safety information

• Use only gas cylinders, which meet national and

regional codes� The minimum cylinder size for this

barbecue is 6kg� Ensure that the cylinder can provide

enough fuel to operate the appliance� If in doubt, check

with your local gas supplier�

• Pay attention that when changing the gas cylinder which

shall be carried our away from any source of ignition�

• Never connect a cylinder, which does not meet

local codes�

• All cylinders 7kg or larger must be placed on the ground

at the rear of the barbecue� Cylinders smaller than 7kg

(maximum size 465mm high by 306mm wide) may be

placed on the hook at the rear (as shown)� Cylinders

must not be exposed to extreme heat or direct sunlight�

• The isolation valve must be turned off when the

appliance is not in use�

• Gas cylinders must be stored in an approved housing out

of reach of children�

• When disconnecting the gas bottle ensure that all the

control valves are in the ‘OFF’ position�

• When reconnecting the hose to the bottle, ensure that

all connections are tight before replacing in storage

compartment�

• Carry out a leakage check as detailed below after each

reconnection�

• Only regulator which complies with EN 16129 can be

used�

• The length of hose cannot exceed 1�5m� In Finland, the

length of hose cannot exceed 1�2m�

• It’s necessary to change the flexible tube when the

national conditions require it, and/or depending on its

validity�

• Make sure that the flexible tube is not subjected to

twisting when the appliance is in operation�

Turndown adjustment screw

Burner

Primary

air shutter

Screw

Primary

air gap

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Beefeater Proline Side Burner Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info