Bedienungsanleitung BEKO ATP 5100 I (Seite 11 von 108) (Deutsch, Englisch, Holländisch, Französisch, Italienisch)

761473

Zoom out

Zoom in

Vorherige Seite

1/108

Nächste Seite

10 / EN

Air purifier/ Instruction Manual

Operating Instructions

5.1 İmportant notes

•Carefully unpack your air purifier.

•Select a firm level place where there are no

obstructions to the air inlet grill or air outlet.

•Remove all PE bags from filters before use.

•Do not point air outlet towards wall.

Power button

Touch the Power button, the machine will

start running under the default “Medium”

setting, and the indicator of “Medium” setting

will illuminate.

Fan speed button

There are 3 speed settings including Low,

Medium and High for selection. Touch the Fan

speed button to select your desired speed

setting.

Timer button

The timer allows you to run your air purifier

at your convenience, for up to 8 hours. With 3

settings including 2hr, 4hr and 8hr.

Ionizer rocker switch

This appliance has an independent Ionizer

rocker switch equipped at the bottom of body,

feature which, when turned on, releases neg-

ative ions into outgoing filtered air to help the

air purification process.

Controls Introduction

Fg.4

Ionizer rocker

switch

Air purifier/ Instruction Manual 11 / EN

To Operate Your Ar Purfer

1. Connect the appliance with power source,

one “Bi” can be heard.

2. Touch the Power button once, “Bi-Bi” can

be heard, the appliance starts to run under

under the default “Medium” setting, and its

corresponding indicator will illuminate. Touch

the “Power button” again if you want to turn

off the appliance.

3. And you can select your required speed set-

ting by following the operation described in

“CONTROLS INTRODUCTION”. After select,

the corresponding indicator of selected speed

setting will turn on.

4. After turn on the air purifier and select your

required speed setting, you can activate the

timer by following the operation as below:

Touch down Timer button on the control

panel, one beep “Bi” can be heard. There are

3 settings including 2H, 4H and 8H for selec-

tion. After select your required timing, the

indicator of selected timing will illuminate.

When the timer expires, the air purifier will

power off automatically and the indicator of

selected timing will extinguish.

NOTE: Hold and Touch the “Pow-

er button” for 2 seconds if you

want to enter into the sleep

mode. To recover, hold and Touch

the “Power button” for 2 seconds

again.

NOTE: The appliance is of mem-

ory function. When being turned

on again, the appliance will work

according to the speed setting

saved last time.

5. When the filter change indicator illumi-

nates in white, it is time to change the HEPA

filter. Please change the HEPA filter by follow-

ing the operation described in the section of

“CHANGE THE HEPA FILTER”.

Ar purfer/ Instructon Manual 11 / 108 EN

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

BEKO ATP 5100 I Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info