Bedienungsanleitung BEKO BHCA66641BBBHS (Seite 15 von 76) (Deutsch, Englisch, Holländisch, Französisch)

816939

Zoom out

Zoom in

Vorherige Seite

1/76

Nächste Seite

EN / 15

If the ambient temperature differ-

ence occurs even when the hob is

not operating while the automatic

mode is active, the temperature

sensor in the product will detect the

difference and the product may

start operating at Speed 2 or 3 de-

pending on the difference. In this

case, automatic mode will be

turned off when the temperature

difference is equalized.

Do not use automatic mode when

your hob is not working.

Air cleaning mode (for models B and C)

You can use air cleaning mode to eliminate

the odour in your house during a long time

at low level.

1. Touch the Speed 1 key for more than 3

seconds.

ðAir cleaning mode is activated. The

light of the Speed 1 key flashes

when the air cleaning mode is act-

ive.

2. The air cleaning mode will operate at

Speed 1 for 10 minutes in 1 hour and

will stop for 50 minutes. If you do not

switch off the air cleaning mode, it will

remain in operation for 10 minutes, then

stop for 50 minutes in each hour for 24

hours.

When air cleaning mode is active, it

is automatically cancelled at the

touch of any key except lamp key.

Your hood continues to operate at

the function of the key you touch.

Aluminium filter fill warning

The light of Speed 2 key flashes for thirty

seconds after every 100 hours of operation.

Clean the aluminium filters. After cleaning,

the lamp warning of Speed 2 key does not

turn off automatically. This product contin-

ues to show the 30-second warning when

the product switches off after every opera-

tion. When you touch the Speed 2 key for

more than 3 seconds, aluminium filter fill

warning is reset and the lamp is turned off.

The warning is not cancelled if the

power is cut when the hood gives

aluminium filter fill warning. When

the power is available, it continues

to warn with the light of Speed 2

key flashing.

If you run the hood at any speed

level with the aluminium filter fill

warning, the warning will not ap-

pear for as long as the hood is run-

ning. When you turn off the hood,

the fill warning starts flashing again

for 30 seconds.

If you turn off the warning without

cleaning the aluminium filter, the

operating time of 100 hours is reset

and it starts over. At the end of the

next 100 hours, your hood warns

again.

Carbon filter fill warning (for products with

carbon filter)

The light of Speed 2 key flashes for thirty

seconds after every 100 hours of operation.

In this case, you must replace your carbon

filter. Consult an authorized service for this.

After replacement, the lamp warning of

Speed 2 key does not turn off automatic-

ally. This product continues to show the 30-

second warning when the product switches

off after every operation. When you touch

the Speed 2 key for more than 3 seconds,

carbon filter fill warning is reset and the

lamp is turned off.

The warning is not cancelled if the

power is cut when the hood gives

carbon filter fill warning. When the

power is available, it continues to

warn with the light of Speed 2 key

flashing.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

BEKO BHCA66641BBBHS Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info