Bedienungsanleitung BEKO CN 236230 (Seite 9 von 80) (Deutsch, Englisch, Polnisch)

556421

Zoom out

Zoom in

Vorherige Seite

1/80

Nächste Seite

Transport instructions

The appliance should be transported only in

upright position.

Before the performance of the working test in the

shop, the packing of the appliance must be intact.

After a transport in the horizontal position, the

device may only be taken into operation 12 hours

after being stood up vertically again.

The appliance must be protected against rain,

moisture and other atmospheric influences.

The manufacturer assumes no liability if safety

instructions are disregarded.

Disposal

Make the device unusable immediately.

Pull out the mains plug and cut the power cable.

Remove or destroy snap or latch locks

before disposing of the device. In this

manner you prevent children from locking

themselves in and endangering their lives.

Device setup

•

Do not operate your appliance in a room where

the temperature is likely to fall below

10°C at night and/or especially in winter. At lower

temperatures the appliance may not operate,

resulting in a reduction in the storage life of the

food.

•

The climate class rate of your appliance is given

in Technical Features leaflet and written on the

rating label inside the appliance. It specifies the

appropriate operating ambient temperatures as

explained below.

Climatic class

Ambient temperatures

SN........................... +10 °C to 32 °C

N ............................ +16 °C to 32 °C

ST .......................... +16 °C to 38 °C

T.............................. +16 °C to 43 °C

SN-ST..................... +10 °C to 38 °C

SN-T ...................... +10 °C to 43 °C

Location

Only place the appliance, as shown in the

illustration in dry rooms which can be aired.

Avoid direct sunlight or direct heat sources such

as a stove or a heater.

If this cannot be avoided, the following minimum

distances should be maintained:

Electric stoves: 3,00 cm

Heater: 3,00 cm

Cooling devices: 2,50 cm

• Ensure sufficient air circulation for your device.

• Make sure that sufficient room is provided

around the appliance to ensure free air circulation

(Item 3).

Fit the two plastic wall spacers supplied with

the appliance rotating 1/4 turn to the condenser at

the back of the appliance (Item 4).

• The appliance should be located on a smooth

surface. The two front feet can be adjusted as

required (Item 5). To ensure that your appliance is

standing upright adjust the two front feet by turning

clockwise or counter-

clockwise, until the product is in

firm contact with the floor.

Correct adjustment of feet avoids excessive

vibration and noise.

Electrical connections

Warning

This appliance must be grounded.

• Check whether the power type and voltage in

your region corresponds to the one stated on the

rating label inside the appliance.

• The electrical safety of the appliance is only

assured when the grounding system in the house is

installed in accordance with regulations.

• When placing the appliance, do not let the power

cable get stuck under it; otherwise the cable will

be damaged.

• Ensure that the plug remains readily accessible.

Do not use a multiple adapter bar or an extension

cable.

EN Instruction for use

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

BEKO CN 236230 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info