Bedienungsanleitung BEKO DC 7112 W (Seite 16 von 32) (Englisch)

684593

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

16 / EN Dryer / User Manual

Make sure that you have an earthed power

outlet socket rated at 13 amps (minimum).

4.1 Attention!

When installed, the socket must be

reachable after installation, or a separate

switch (which can disconnect the two poles)

must be used in the installation. Check for

suitability.For a permanent connection, a

master switch with at least 3mm contact

clearance and minimum 13 A rating must be

used.

4.2 Electrical requirements

Before you insert the plug into the wall

socket make sure that the voltage and

the frequency shown in the rating label

corresponds to your electricity supply.

We recommend that this appliance be

connected to the mains supply via a suitable

switched and fused socket in a readily

accessible position. Should the mains lead

of the appliance become damaged or need

replacing at any time, it must be replaced by

a special purpose made mains lead which can

only be obtained from a Authorised Service

Agent.

Warning

This appliance must be earthed

If the fitted moulded plug is not suitable for

your socket, then the plug should be cut off

and an appropriate plug fitted.

The moulded plug on this appliance

incorporates a 13A fuse. Should the fuse

need to be replaced an ASTA approved

BS1362 fuse of the same rating must be

used. Do not forget to refit the fuse cover.

In the event of losing the fuse cover, the

plug must not be used until a replacement

fuse cover has been fitted. Colour of the

replacement fuse cover must be the same

colour as that visible on the pin face of the

plug. Fuse covers are available from any good

electrical store.

In order to avoid hazards, damaged supply

cord should be replaced by the manufacturer,

its service agent or similarly qualified people.

Built-under installation

This appliance can be installed under a

worktop.

Do not operate without the top

cover fitted. Risk of injury.

Important

4.3 Fitting a different plug

As the colours of the wires in the mains

lead of this appliance may not correspond

with the coloured markings identifying the

terminals on your plug, proceed as follows:

1 Connect the green - yellow or green (earth)

wire to the terminal in the plug marked ‘E’

or with the symbol or coloured green and

yellow or green.

2 Connect the blue (neutral) wire to the

terminal in the plug marked ‘N’ or coloured

black.

3 Connect the brown (live) wire to the

terminal in the plug marked ‘L’ or coloured

red.

Green and yellow

or green

Blue or black

Brown or red

With the alternative plugs a 13A fuse must

be fitted either in the plug or adaptor or

in the main fuse box. If in doubt contact a

qualified electrician.

4.4 Washer/dryer combination

Do not stack washing machine on top of

the tumble dryer. This would damage both

appliances and guarantees would become

void. It is also unsafe to stack an appliance

on top of another without using a suitable

and approved stacking kit obtained from the

manufacturer of the appliances.

• A special stacking kit is required as an

optional extra please contact customer

service.

4 Electrcal Connecton

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

BEKO DC 7112 W Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von BEKO DC 7112 W

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info