Bedienungsanleitung BEKO DSN05N10X (Seite 31 von 40) (Englisch)

757753

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

31/EN

Starting the programme

To start your machine after selecting the

programme and auxiliary functions, press

Start/Pause/Cancel key.

Your machine performs water softening

depending on the hardness level of the

mains water. Due to water softening

process the programme duration may

change. The programme duration can also

change while the programme is running

depending on the ambient temperature

where your machine is installed,

temperature of the supply water and

amount of the dishes.

Pay attention not to open the door of

the machine when it is running. Stop the

machine by pressing Start/Pause/Cancel

key if you have to open the door. Then,

open the door of the machine. There may

be a rush of vapour when you open the

door of your machine; be careful. Close

the door of your machine and press Start/

Pause/Cancel key again. Programme will

resume running.

After the rinsing step, the machine

will wait silent in pause mode for

some time in order to have the water

remaining in the machine and on the

dishes drained completely and to have

the water softener cleaned, and then it

will resume running in drying mode.

Programme follow-up

You can track the current step of the

selected programme on the programme

step lights located on the control panel.

If the drying light is on, the machine

will perform silent drying for 30-60 minutes.

At the end of this period, the Drying light

will go off and the End light will become on.

The End light will become on when the

selected washing programme ends.

Cancelling the programme

1. Press and hold the Start / Pause /

Cancel key for 3 seconds to cancel the

programme.

2. Release it when the Washing and

Drying lights start flashing. Water in

the machine will be discharged in 45

seconds. The programme will have

been cancelled once the Washing and

Drying lights go off and the End light

becomes on. Then, you can select and

operate a new programme.

There might be residues of detergent

or rinse aid left in the machine and/or on

the pieces being washed depending on

the step in which the programme has been

cancelled.

When you set the Programme

Selection Knob to “Off” position, the

washing programme will end and the

machine will be ready for a new programme

selection. If you end the washing cycle this

way, water and detergent may remain in the

machine.

Salt indicator

Please check the salt indicator to see

whether there is adequate amount of

softening salt in the dishwasher or not.

You need to refill the salt reservoir with salt

whenever the no-salt warning symbol lights.

Adjusting the water hardness level

is explained in Water Softening System

section.

Rinse Aid indicator

Please check the rinse aid indicator to see

whether there is adequate amount of rinse

aid in the dishwasher or not. You need to

refill the rinse aid dispenser with rinse aid

whenever the no rinse aid warning symbol

lights.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

BEKO DSN05N10X Seite 31

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von BEKO DSN05N10X

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info