Bedienungsanleitung BEKO DTGC10000 (Seite 19 von 24) (Englisch)

757698

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

Dryer / User Manual

8 Electrical Connection

Make sure that you have an earthed power

outlet socket rated at 13 amps (minimum).

8.1 Attention!

When installed, the socket must be reachable

after installation, or a separate switch (which

can disconnect the two poles) must be used

in the installation. Check for suitability.For a

permanent connection, a master switch with at

least 3mm contact clearance and minimum 13

A rating must be used.

8.2 Electrical requirements

Before you insert the plug into the wall socket

make sure that the voltage and the frequency

shown in the rating label corresponds to your

electricity supply.

We recommend that this appliance be

connected to the mains supply via a suitable

switched and fused socket in a readily

accessible position. Should the mains lead

of the appliance become damaged or need

replacing at any time, it must be replaced by a

special purpose made mains lead which can

only be obtained from a Authorised Service

Agent.

AWARNING!

This appliance must be earthed

If the fitted moulded plug is not suitable for

your socket, then the plug should be cut off

and an appropriate plug fitted.

The moulded plug on this appliance

incorporates a 13A fuse. Should the fuse need

to be replaced an ASTA approved BS1362

fuse of the same rating must be used. Do not

forget to refit the fuse cover. In the event of

losing the fuse cover, the plug must not be

used until a replacement fuse cover has been

fitted. Colour of the replacement fuse cover

must be the same colour as that visible on the

pin face of the plug. Fuse covers are available

from any good electrical store.

In order to avoid hazards, damaged supply

cord should be replaced by the manufacturer,

its service agent or similarly qualified people.

Built-under installation

This appliance can be installed under a

worktop.

AWARNING!

Do not operate without the top cover fitted.

Risk of injury.

AIMPORTANT!

8.3 Fitting a different plug

As the colours of the wires in the mains lead

of this appliance may not correspond with the

coloured markings identifying the terminals on

your plug, proceed as follows:

1 Connect the green - yellow or green (earth)

wire to the terminal in the plug marked ‘E’ or

with the symbol or coloured green and yellow

or green.

2 Connect the blue (neutral) wire to the terminal

in the plug marked ‘N’ or coloured black.

3 Connect the brown (live) wire to the terminal

in the plug marked ‘L’ or coloured red.

With the alternative plugs a 13A fuse must

be fitted either in the plug or adaptor or in the

main fuse box. If in doubt contact a qualified

electrician.

Green and yellow

or green

Blue or black

Brown or red

8.4 Washer/dryer combination

Do not stack washing machine on top of

the tumble dryer. This would damage both

appliances and guarantees would become

void. It is also unsafe to stack an appliance

on top of another without using a suitable

and approved stacking kit obtained from the

manufacturer of the appliances.

• A special stacking kit is required as an

optional extra please contact customer service.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

BEKO DTGC10000 Seite 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info