Bedienungsanleitung BEKO HCP 91400 I (Seite 9 von 19) (Deutsch, Englisch, Holländisch, Französisch)

816949

Zoom out

Zoom in

Vorherige Seite

1/19

Nächste Seite

exhaust fumes from appliances burning

gas or other fuels.

Do not use or leave the hood without the

lamp correctly mounted due to the

possible risk of electric shocks.

Never use the hood without effectively

mounted grids.

The hood must NEVER be used as a

support surface unless specifically

indicated.

Use only the fixing screws supplied with

the product for installation or, if not

supplied, purchase the correct screws

type.

Use the correct length for the screws

which are identified in the Installation

Guide.

In case of doubt, consult an authorised

service assistance centre or similar

qualified person.

WARNING! Failure to install the screws

or fixing device in accordance with these

instructions may result in electrical

hazards.

We will not accept any responsibility for

any faults, damage or fires caused to the

appliance as a result of the non-

observance of the instructions included in

this manual.

This appliance is marked according to the European directive

2012/19/EC on Waste Electrical and Electronic Equipment

(WEEE). By ensuring this product is disposed of correctly, you

will help prevent potential negative consequences for the

environment and human health, which could otherwise be

caused by inappropriate waste handling of this product.

The symbol on the product, or on the documents

accompanying the product, indicates that this appliance may

not be treated as household waste. Instead it should be taken

to the appropriate collection point for the recycling of electrical

and electronic equipment. Disposal must be carried out in

accordance with local environmental regulations for waste

disposal.

For further detailed information regarding the process,

collection and recycling of this product, please contact the

appropriate department of your local authorities or the local

department for household waste or the shop where you

purchased this product.

Appliance designed, tested and manufactured according to:

•Safety: EN/IEC 60335-1; EN/IEC 60335-2-31, EN/IEC

62233.

•Performance: EN/IEC 61591; ISO 5167-1; ISO 5167-3; ISO

5168; EN/IEC 60704-1; EN/IEC 60704-2-13; EN/IEC 60704-3;

ISO 3741; EN 50564; IEC 62301.

•EMC: EN 55014-1; CISPR 14-1; EN 55014-2; CISPR 14-2;

EN/IEC 61000-3-2; EN/IEC 61000-3-3. Suggestions for a

correct use in order to reduce the environmental impact:

Switch ON the hood at minimum speed when you start

cooking and kept it running for few minutes after cooking is

finished. Increase the speed only in case of large amount of

smoke and vapour and use boost speed(s) only in extreme

situations. Replace the charcoal filter(s) when necessary to

maintain a good odour reduction efficiency. Clean the grease

filter(s) when necessary to maintain a good grease filter

efficiency. Use the maximum diameter of the ducting system

indicated in this manual to optimize efficiency and minimize

noise.

Use

The hood is designed to be used either for exhausting or filter

version.

Ducting version

The hood is equipped with a top air outlet B for discharge of

fumes to the outside (exhaust pipe and pipe fixing clamps not

provided).

Connect the hood and discharge holes on the walls with a

diameter equivalent to the air outlet (connection flange).

Using the tubes and discharge holes on walls with smaller

dimensions will cause a diminution of the suction performance

and a drastic increase in noise.

Any responsibility in the matter is therefore declined.

Attention! If the hood is supplied with carbon lter, then it

must be removed.

Filter version

In the case of not being able to discharge the fumes and the

steam of cooking outside, the hood in the lter version can

be used mounting the F deflector on the flue and one or more

carbon filters (on the basis of the model possessed). The

fumes and steam are recycled into the kitchen through upper

grill H.

Attention! If the hood is not supplied with carbon lter,

then it must be ordered and mounted.

The models with no suction motor only operate in ducting

mode, and must be connected to an external suction device

(not supplied).

The connecting instructions are supplied with the peripheral

suction unit.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

BEKO HCP 91400 I Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info