Bedienungsanleitung BEKO HSA 40520 (Seite 9 von 68) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch)

476008

Zoom out

Zoom in

Vorherige Seite

1/68

Nächste Seite



Excess deposit of ice on the frame and the

baskets should be removed regularly with the

plastic scraper provided. Do not use any

metal parts to remove the ice.

The presence of this ice build-up makes

impossible to close the door correctly.



If you do not use your appliance for a few

days, it is not advisable to switch it off. If you

do not use it for a longer period, please

proceed as follows :

- unplug the appliance;

- empty the freezer;

- defrost it and clean it;

leave the door open to avoid the formation of

unpleasant smells.



The supply cord can be replaced only by

an authorised person.



If your appliance has a lock, keep it locked

and store the key in a safe place, out of the

reach of children. If you are discarding an

appliance with lock, make sure that, is made

ineffective. This is very important so as to

avoid children being trapped inside, which

may cause their loss of life.



If the supply cord is damaged, it must be

replaced by the manufacturer, its service

agent or similarly qualified persons in order to

avoid a hazard.

Setting up

This appliance was designed to operate at an

ambient temperature between +10

C and

+43

C (SN/T class). If the ambient

temperature is above +43

C, inside the

appliance the temperature can increase.

Set up the appliance far from any source of

heat and fire. Placing it in a warm room, the

direct exposure to sunbeams or near a heat

source (heaters, cookers, ovens), will

increase the energy consumption and shorten

the product life.

• Please observe the following minimun

distances:

• 100 cm from the cookers working with

coal or oil;

• 150 cm from the electric and gas

cookers.

•

Ensure the free circulation of the air around

the appliance, by observing the distances

shown in Item 2.

Assemble on the condenser (in the rear side)

the supplied spacers. (Item 3).

• Place the appliance in a perfectly even, dry

and well ventilated place.

Assemble the supplied accessories.

Electric connection

Your appliance is intended to operate at a

single-phase voltage of 220-

240V/50 Hz. Before

plugging in the appliance, please make sure

that the parameters of the mains in your house

(voltage, currect type, frequency) comply to the

operation parameters of the appliance.

• The information concerning the supply voltage

and the absorbed power is given on the marking

label placed in the back side of the freezer.

• The electric installation must comply with

the law requirements.

• The earthing of the appliance is

compulsory. The manufacturer has no

responsibility for any damage to persons,

animals or goods which may arise from

the failure to observe the specified

conditions.

• The appliance is endowed with a supply

cord and a plug (European type, marked

10/16A) with double earthing contact for

safety. If the socket is not the same type with

the plug, please ask a specialised electrician

to change it.

•

Do not use extension pieces or multiple

adapters.

EN Instruction for use

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

BEKO HSA 40520 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von BEKO HSA 40520

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info