Bedienungsanleitung BEKO HTV8716XWST (Seite 37 von 44) (Englisch)

816581

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite

37 / EN Washer-Dryer / User Manual

After every washing and

drying make sure that

no foreign substance is

left in the drum.

If the holes on the

bellow shown in the

figure are blocked,

open the holes using a

toothpick.

INFORMATION

• Foreign metal substances will cause rust

stains in the drum. Clean the stains on the

drum surface by using cleaning agents for

stainless steel. Never use steel wool or wire

wool.

CAUTION!

• Never use sponge or scrub materials.

These will damage the painted, chrome

and plastic surfaces.

6.3 Cleaning the body

and control panel

Wipe the body of the machine with soapy

water or non-corrosive mild gel detergents as

necessary, and dry with a soft cloth.

Use only a soft and damp cloth to clean the

control panel.

6.4 Cleaning the water

intake filters

There is a filter at the end of each water intake

valve at the rear of the machine and also at

the end of each water intake hose where they

are connected to the tap. These filters prevent

foreign substances and dirt in the water to enter

the washing machine. Filters should be cleaned

if they are dirty.

1. Close the taps.

2. Remove the nuts of the water intake

hoses to access the filters on the water

intake valves. Clean residues on them

with an appropriate brush. If the filters are

too dirty, remove them from their places

with a pliers and clean in this way.

3. Take out the filters on the flat ends of the

water intake hoses together with the gaskets

and clean thoroughly under running water.

4. Replace the gaskets and filters carefully

in their places and tighten the hose nuts

by hand ensuring there are no leaks.

6.5 Draining remaining water

and cleaning the pump filter

The filter system in your machine prevents solid

items such as buttons, coins and fabric fibres

clogging the pump impeller during discharge of

washing water. Thus, the water will be drained

without any problem and the service life of the

pump will extend.

If the machine fails to drain water, the pump filter

is clogged. Filter must be cleaned whenever it

is clogged or in every 3 months. Water must be

drained off first to clean the pump filter.

In addition, prior to transporting the machine

(e.g., when moving to another house) and in

case of freezing of the water, water may have to

be drained completely.

CAUTION!

• Foreign substances left in the pump filter

may damage your product or may cause

noise problem.

• If the product is not being used, shut the

tap, remove mains hose and drain the

water inside the machine in places where

there is the risk of the product freezing .

• After each use, turn off the water tap to

which the mains hose is connected.

1. In order to clean the dirty filter and

discharge the water, unplug the

machine to cut off the supply power.

CAUTION!

• Temperature of the water inside the

machine may rise up to 90 ºC. To avoid

the risk of burning, clean the filter after the

water inside the machine is cooled down.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

BEKO HTV8716XWST Seite 37

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von BEKO HTV8716XWST

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info