Bedienungsanleitung BEKO RCNE560E41DZXP (Seite 9 von 152) (Deutsch, Englisch, Französisch)

677002

Zoom out

Zoom in

Vorherige Seite

1/152

Nächste Seite

8 /33 EN

Refrigerator / User Guide

3 Installation

3.1. Right place for installation

Contact the Authorized Service for the product's

installation. To ready the product for installation, see

the information in the user guide and make sure the

electric and water utilities are as required. If not, call

an electrician and plumber to arrange the utilities as

necessary.

WARNING: The manufacturer assumes

no responsibility for any damage caused

by the work carried out by unauthorized

persons.

WARNING: The product’s power cable

must be unplugged during installation.

Failure to do so may result in death or

serious injuries!

WARNING: If the door span is too narrow

for the product to pass, remove the door

and turn the product sideways; if this does

not work, contact the authorized service.

• Placetheproductonaflatsurfacetoavoidvibration.

• Placetheproductatleast30cmawayfromthe

heater, stove and similar sources of heat and at least

5 cm away from electric ovens.

•Donotexposetheproducttodirectsunlightorkeep

in damp environments.

• Theproductrequiresadequateaircirculationto

function efficiently.

• Iftheproductwillbeplacedinanalcove,remember

to leave at least 5 cm distance between the product

and the ceiling and the walls.

• Donotinstalltheproductinenvironmentswith

temperatures below -5°C.

3.2. Attaching the plastic wedges

Use the plastic wedges in the provided with the product

to provide sufficient space for air circulation between the

product and the wall.

To attach the wedges, remove the screws on the product

and use the screws provided with the wedges.

Attach 2 plastic wedges on the ventilation cover as shown

in the figure.

3.3. Adjusting the stands

If the product is not in balanced position, adjust the front

adjustable stands by rotating right or left.

3.4. Power connection

WARNING: Do not use extension or multi

sockets in power connection.

WARNING: Damaged power cable must

be replaced by Authorized Service.

When placing two coolers in adjacent

position, leave at least 4 cm distance

between the two units.

• Our firm will not assume responsibility for any

damages due to usage without earthing and

power connection in compliance with national

regulations.

• The power cable plug must be easily accessible

after installation.

• Do not use multi-group plug with or without

extension cable between the wall socket and the

refrigerator.

Hot Surface Warning!

Side walls of your product is equipped

with refrigerant pipes to improve the

cooling system. Refrigerant with high

temperatures may flow through these

areas, resulting in hot surfaces on the

side walls. This is normal and does not

need any servicing. Please pay attention

while touching these areas.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

BEKO RCNE560E41DZXP Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info