Bedienungsanleitung BEKO TSE 1283 (Seite 8 von 92) (Englisch)

556369

Zoom out

Zoom in

Vorherige Seite

1/92

Nächste Seite

3 Installation

C Please remember that the manufacturer

shall not be held liable if the information

given in the instruction manual is not

observed.

Preparation

• Your refrigerator should be installed at

least 30 cm away from heat sources

such as hobs, ovens, central heater

and stoves and at least 5 cm away

from electrical ovens and should not be

located under direct sunlight.

• The ambient temperature of the room

where you install your refrigerator

should at least be 10°C. Operating your

refrigerator under cooler conditions

than this is not recommended with

regard to its efficiency.

• Please make sure that the interior of

your refrigerator is cleaned thoroughly.

• If two refrigerators are to be installed

side by side, there should be at least 2

cm distance between them.

• Original packaging and foam

materials should be kept for future

transportations or moving.

Points to be considered

when re-transporting your

refrigerator

1. Your refrigerator must be emptied and

cleaned prior to any transportation.

2. Shelves, accessories, crisper and etc.

in your refrigerator must be fastened

securely by adhesive tape against any

jolt before repackaging.

3. Packaging must be tied with thick

tapes and strong ropes and the rules of

transportation printed on the package

must be followed.

Please do not forget…

Every recycled material is an

indispensable source for the nature and

for our national resources.

If you wish to contribute to recycling the

packaging materials, you can get further

information from the environmental

bodies or local authorities.

Before operating your

refrigerator

Before starting to use your refrigerator

check the following:

1- Is the interior of the refrigerator dry and

can the air circulate freely in the rear of

it?

2- Clean the interior of the refrigerator as

recommended in the “Maintenance and

cleaning” section.

3- Plug the refrigerator into the wall outlet.

When the door is open the respective

interior light will come on.

4- You will hear a noise as the compressor

starts up. The liquid and gases sealed

within the refrigeration system may

also give rise to noise, even if the

compressor is not running and this is

quite normal. Due to the operation of

fans inside the appliance, overall noise

level is slightly higher in comparison to

non-frost free appliances. This is quite

normal and is not a fault.

5- Front edges of the refrigerator may

feel warm. This is normal. These areas

are designed to be warm to avoid

condensation.

Adjusting the legs

If your refrigerator is unbalanced;

You can balance your refrigerator by

turning the front legs of it as illustrated in

the figure. The corner where the leg exists

is lowered when you turn in the direction

of black arrow and raised when you turn

in the opposite direction. Taking help from

someone to slightly lift the refrigerator will

facilitate this process.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

BEKO TSE 1283 Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von BEKO TSE 1283

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info