Bedienungsanleitung BEKO WDIK854451 (Seite 13 von 56) (Englisch)

817031

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

13 / EN Washer-Dryer / User Manual

• If the hose is run along the floor (or at less

than 40 cm above it) and raised later on,

water drain becomes difficult and laundry

may come out extremely wet. Therefore,

observe the heights described in the figure.

• To prevent flowing of dirty water back into

the machine and to allow for easy discharge,

do not immerse the hose end into the dirty

water or do not drive it in the drain more

than 15 cm. If it is too long, cut it short.

• The end of the hose should not be

bent, it should not be stepped on

and the hose must not be pinched

between the drain and the machine.

• If the length of the hose is too short, add an

original extension hose. Length of the hose

may not be longer than 3.2 m. To avoid water

leak failures, the connection between the

extension hose and the drain hose of the

product must be fitted well with an appropriate

clamp as not to come off and leak.

3.6 Adjusting the feet

CAUTION!

• Adjust feet so that the product will be

balanced in the location it will be used.

• Balance the machine by adjusting the feet.

• Check for any play by pressing the product

from upper diagonal edges.

• Otherwise, the product may move from

its place and cause crushing, noise and

vibration problems.

• Do not use any tools to loosen the lock

nuts. Otherwise, the lock nuts may get

damaged.

a) Loosen the lock nuts on the feet by hand.

b) Adjust the feet until the product

stands level and balanced.

c) Tighten all lock nuts again by hand.

Adjusting the feet with water level

• You must remove the Detergent

Drawer to set the Water Level.

• For the system to operate properly, the bubble

inside the Water Level must be in the

middle

• If the bubble inside the Water Level is

on the

left

, the pre-set

right

foot of the

Washing Machine must be adjusted.

• If the bubble inside the Water Level is

on the

right

, the pre-set

left

foot of the

Washing Machine must be adjusted.

• If the bubble inside the Water Level is at the

back

, the pre-set

front

feet of the Washing

Machine must be turned to the left (clockwise).

• If the bubble inside the Water Level

is at the

front

, the pre-set

front

feet

of the Washing Machine must be

turned to the right (anti-clockwise).

3.7 Electrical connection

Connect the product to a grounded outlet

protected by a 13 A fuse. Our company shall

not be liable for any damages that will arise

when the product is used without grounding in

accordance with the local regulations.

• Connection must comply with

national regulations.

• The wiring for the electrical outlet circuit

must be sufficient to meet the appliance

requirements. Use of a Groud Fault Circuit

Interrupter (GFCI) is recommended.

• Power cable plug must be within

easy reach after installation.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

BEKO WDIK854451 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info