Bedienungsanleitung BEKO WEY96054 (Seite 9 von 40) (Englisch)

758298

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

9 / EN Washing Machine / User Manual

4.1.7 Electrical connection

Connect the product to a grounded outlet protected by a 13 A fuse. Our company shall not be liable for any

damages that will arise when the product is used without grounding in accordance with the local regulations.

• Connection must comply with national regulations.

• The wiring for the electrical outlet circuit must be sufficient to meet the appliance requirements. Use of a

Groud Fault Circuit Interrupter (GFCI) is recommended.

• Power cable plug must be within easy reach after installation.

• If the current value of the fuse or breaker in the house is less than 13 Amps, have a qualified electrician

install a 13 Amp fuse.

• The voltage specified in the “Technical specifications” section must be equal to your mains voltage.

• Do not make connections via extension cables or multi-plugs.

BWARNING: Damaged power cables must be replaced by Authorised Service Agents.

Electrical requirements

Before you insert the plug into the wall socket make sure that the voltage and the frequency shown in the

rating label corresponds to your electricity supply.

We recommend that this appliance be connected to the mains supply via a suitable switched and fused socket

in a readily accessible position.

Should the mains lead of the appliance become damaged or need replacing at any time, it must be replaced

by a special purpose made mains lead which can only be obtained from an Authorised Service Agent.

BWARNING: This appliance must be earthed

If the fitted moulded plug is not suitable for your socket, then the plug should be cut off and an appropriate

plug fitted.

Destroy the old plug, a cut off plug with a bare cord could cause a shock hazard if inserted into a socket

elsewhere in the house.

The moulded plug on this appliance incorporates a 13A fuse. Should the fuse need to be replaced an ASTA

approved BS1362 fuse of the same rating must be used. Do not forget to refit the fuse cover. In the event of

losing the fuse cover, the plug must not be used until a replacement fuse cover has been fitted. Colour of the

replacement fuse cover must be the same colour as that visible on the pin face of the plug. Fuse covers are

available from any good electrical store.

Important

Fitting a different plug

As the colours of the wires in the mains lead of this appliance may not

correspond with the coloured markings identifying the terminals on your

plug, proceed as follows:

1 Connect the green - yellow or green (earth) wire to the terminal in

the plug marked ‘E’ or with the symbol or coloured green and

yellow or green.

2 Connect the blue (neutral) wire to the terminal in the plug marked

‘N’ or coloured black.

3 Connect the brown (live) wire to the terminal in the plug marked ‘L’

or coloured red.

With the alternative plugs a 13A fuse must be fitted either in the plug or

adaptor or in the main fuse box. If in doubt contact a qualified electrician.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

BEKO WEY96054 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info