Bedienungsanleitung BEKO WM74155LS (Seite 10 von 36) (Englisch)

556827

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

install a 13 Amp fuse.

• The specified voltage must be equal

to your mains voltage.

• Do not make connections via

extension cables or multi-plugs.

Damaged power cables must be

replaced by the Authorized Service

Agents.

Electrical requirements

Before you insert the plug into the wall

socket make sure that the voltage and

the frequency shown in the rating label

corresponds to your electricity supply.

We recommend that this appliance be

connected to the mains supply via a

suitable switched and fused socket in a

readily accessible position.

Should the mains lead of the appliance

become damaged or need replacing at

any time, it must be replaced by a special

purpose made mains lead which can only

be obtained from a Authorised Service

Agent.

This appliance must be earthed

If the fitted moulded plug is not suitable

for your socket, then the plug should be

cut off and an appropriate plug fitted.

Destroy the old plug, which is cut off as

a plug with a bared cord could cause a

shock hazard if inserted into a socket

elsewhere in the house.

The moulded plug on this appliance

incorporates a 13A fuse. Should the fuse

need to be replaced an ASTA approved

BS1362 fuse of the same rating must be

used. Do not forget to refit the fuse cover.

In the event of losing the fuse cover, the

plug must not be used until a replacement

fuse cover has been fitted. Colour of the

replacement fuse cover must be the same

colour as that visible on the pin face of the

plug. Fuse covers are available from any

good electrical store.

Important

Fitting a different plug

As the colours of the wires in the mains

lead of this appliance may not correspond

with the coloured markings identifying

the terminals on your plug, proceed as

follows:

1 Connect the green - yellow or green

(earth) wire to the terminal in the plug

marked ‘E’ or with the symbol f or

coloured green and yellow or green.

2 Connect the blue (neutral) wire to the

terminal in the plug marked ‘N’ or

coloured black.

3 Connect the brown (live) wire to the

terminal in the plug marked ‘L’ or

coloured red.

With the alternative plugs a 13A fuse must

be fitted either in the plug or adaptor or in the

main fuse box. If in doubt contact a qualified

electrician.

First use

Before starting to use the product, make

sure that all preparations are made in

accordance with the instructions in

sections "Important safety instructions"

and "Installation".

To prepare the product for washing

laundry, perform first operation in Drum

Cleaning programme. If your machine

is not featured with Drum Cleaning

programme, use Cottons-90 programme

and select Additional Water or Extra Rinse

auxiliary functions as well. Before starting

the programme, put max. 100 g of

powder anti-limescale into the main wash

detergent compartment (compartment nr.

II). If the anti-limescale is in tablet form,

put only one tablet into compartment nr.

II. Dry the inside of the bellow with a clean

piece of cloth after the programme has

come to an end.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

BEKO WM74155LS Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info