Bedienungsanleitung BEKO WMB 61232 MC (Seite 66 von 84) (Deutsch, Englisch, Holländisch, Französisch)

676611

Zoom out

Zoom in

Vorherige Seite

1/84

Nächste Seite

66 / EN

Washing Machine / User’s Manual

Keep the transportation safety bolts in a safe place to

reuse when the washing machine needs to be moved

again in the future.

Never move the product without the transportation safety

bolts properly ﬁxed in place!

2.4 Connecting water supply

The water supply pressure required to run the product is

between 1 to 10 bars (0.1 – 1 MPa). It is necessary to

have 10 – 80 liters of water ﬂowing from the fully open

tap in one minute to have your machine run smoothly.

Attach a pressure reducing valve if water pressure is

higher.

If you are going to use the double water-inlet product

as a single

(cold) water-inlet unit, you must install the

supplied stopper to the hot water valve before operating

the product. (Applies for the products supplied with a

blind stopper group.)

WARNİNG: Models with a single water inlet should not be

connected to the hot water tap. In such a case the laundry

will get damaged or the product will switch to protection

mode and will not operate.

WARNİNG: Do not use old or used water inlet hoses on the

new product. It may cause stains on your laundry.

1. Connect the special hoses supplied with the product to

the water inlets on the product. Red hose (left) (max. 90

ºC) is for hot water inlet, blue hose (right) (max. 25 ºC) is

for cold water inlet.

WARNİNG: Ensure that the cold and hot water connections

are made correctly when installing the product.

Otherwise, your laundry will come out hot at the end of

the washing process and wear out.

2. Tighten all hose nuts by hand. Never use a tool when

tightening the nuts.

3. Open the taps completely after making the hose

connection to check for water leaks at the connection

points. If any leaks occur, turn off the tap and remove the

nut. Retighten the nut carefully after checking the seal. To

prevent water leakages and damages caused by them,

keep the taps closed when the machine is not in use.

2.5 Connecting to the drain

• The end of the drain hose must be directly connected to

the wastewater drain or to the washbasin.

WARNİNG: Your house will be ﬂooded if the hose comes

out of its housing during water discharge. Moreover, there

is risk of scalding due to high washing temperatures!

To prevent such situations and to ensure smooth water

intake and discharge of the machine, ﬁx the end of the

discharge hose tightly so that it cannot come out.

• The hose should be attached to a height of at least 40

cm, and 100 cm at most.

• In case the hose is elevated after laying it on the ﬂoor

level or close to the ground (less than 40 cm above the

ground), water discharge becomes more difﬁcult and the

laundry may come out excessively wet. Therefore, follow

the heights described in the ﬁgure.

• To prevent ﬂowing of dirty water back into the machine

and to allow for easy discharge, do n

ot immerse the hose

end into the dirty water or do not drive it in the drain more

than 15 cm. If it is too long, cut it short.

• The end of the hose should not be bent, it should not be

stepped on and the hose must not be pinched between

the drain and the machine.

• If the length of the hose is too short, use it by adding

an original extension hose. Length of the hose may

not be longer than 3.2 m. To avoid water leak failures,

the connection between the extension hose and the

drain hose of the product must be ﬁtted well with an

appropriate clamp as not to come off and leak.

2.6 Adjusting the feet

WARNİNG: In order to ensure that the product operates

more silently and vibration-free, it must stand level and

balanced on its feet. Balance the machine by adjusting

the feet. Otherwise, the product may move from its place

and cause crushing and vibration problems.

1. Loosen the lock nuts on the feet by hand.

2. Adjust the feet until the product stands level and

balanced.

3. Tighten all lock nuts again by hand.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

BEKO WMB 61232 MC Seite 66

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info