Bedienungsanleitung BEKO WMB 91242 (Seite 24 von 40) (Englisch)

457431

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

24 - EN

Quick instructions for daily use

Preparation

1. Turn the tap on completely. Check that

the hose is connected tightly.

2. Placethelaundryinthemachine.

3. Add detergent and softener.

Starting

1. Pressthe“On/Off”button.

2. Select the programme and the

temperature.

3. Ifdesired(accordingtoyourmachine’s

model):

– select any auxiliary function,

– adjust the spin speed,

– set the time delay,

4. Close the loading door.

5. Press“Start/Pause/Cancel”button.

The display shows the time remaining for

the programme to complete if time delay is

not set.

The display shows the time remaining for

the programme to start if the time delay is

set.

6. Check if the Door Locked Symbol lights

up on the screen.

TheDoorLockedSymbol(Figure3-13i)will

light up if time delay is not set.

TheDoorLockedSymbol(Figure3-13i)will

fade if time delay is set.

Cancelling a programme

1. Pressandholdthe“Start/Pause/

Cancel”buttonforabout3seconds;the

Start symbol will start flashing.

2. The machine can discharge all the

water or can take in water for 3 times

at most to cool down the clothes and

complete discharging process.

Adding more laundry

•

This is only possible under the following

conditions:

– during time delay,

Youmayaddorremovelaundryduring

thetimedelay(untiltheprogramme

starts).Atthebeginningofawashing

cycle(machineallowsaddingmore

laundry during a future step only if the

water level is low enough to open the

loading door or if the temperature in the

machineislow).

In order to add laundry after the start-up

oftheprogramme:

1. Press“Start/Pause/Cancel”button.

2. Opentheloadingdoorandputinmore

laundry.

3. Close the loading door.

4. Press“Start/Pause/Cancel”button.

Programme is in rinse hold mode

This process is shown with the flashing

spin symbol and the standby symbol

which is lit up.

If you wish to spin when the machine is in

thismode:

1. Adjust the spin speed.

2. Press“Start/Pause/Cancel”button.The

programme continues, pumps out the

water and spins.

3. The standby symbol fades out and the

start symbol lights up.

If you want to discharge the water without

spinning:

1. Press“Start/Pause/Cancel”button.

2. The standby symbol fades out and the

start symbol lights up.

3. The programme continues and only

pumps out the water.

Re-spinning the laundry

The control system for an unbalanced load

can pause the spinning in cases when the

distribution of the laundry in the drum is not

balanced.

Ifyouwanttore-spintheclothes:

1. Distribute the laundry in your machine

for a balanced load.

2. Select the spin programme.

3. Adjust the spin speed.

After the programme is finished

Programmeindicatorsymbolsonthe

screen will remain lit after the programme is

finished.“End”willappearonthescreen.

1. Opentheloadingdoorandtakeoutthe

laundry when the door locked symbol

on the display fades out.

2. Pressthe“On/Off”button.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

BEKO WMB 91242 Seite 24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info