Bedienungsanleitung BEKO WMB61221 (Seite 32 von 40) (Englisch)

556837

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

Loading door cannot be opened.

• Door lock is activated because of the water level in the machine. >>> Drain the

water by running the Pump or Spin programme.

• Machine is heating up the water or it is at the spinning cycle. >>> Wait until the

programme completes.

• Child lock is engaged. Door lock will be deactivated a couple of minutes after

the programme has come to an end. >>> Wait for a couple of minutes for

deactivation of the door lock.

Washing takes longer time than the one specified in the manual.

• Water pressure is low. >>> Machine waits until taking in adequate amount of

water to prevent poor washing quality due to the decreased amount of water.

Therefore, the washing time extends.

• Voltage might be low. >>> Washing time is prolonged to avoid poor washing

results when the supply voltage is low.

• Input temperature of water might be low. >>> Required time to heat up the water

extends in cold seasons. Also, washing time can be lengthened to avoid poor

washing results.

• Number of rinses and/or amount of rinse water might have increased. >>>

Machine increases the amount of rinse water when good rinsing is needed and

adds an extra rinsing step if necessary.

• Excessive foam might have occurred and automatic foam absorption system

might have been activated due to too much detergent usage. >>> Use

recommended amount of detergent.

Machine does not switch to spinning step when the laundry is not evenly

distributed in the drum to prevent any damage to the machine and to its

surrounding environment. Laundry should be rearranged and re-spun.

Programme time does not countdown. (On models with display)

• Timer may stop during water intake. >>> Timer indicator will not countdown until

the machine takes in adequate amount of water. The machine will wait until there

is sufficient amount of water to avoid poor washing results due to lack of water.

Timer indicator will resume countdown after this.

• Timer may stop during heating step. >>> Timer indicator will not countdown until

the machine reaches the selected temperature.

• Timer may stop during spinning step. >>> Automatic unbalanced load detection

system might be activated due to the unbalanced distribution of the laundry in the

drum.

Machine does not switch to spinning step when the laundry is not evenly

distributed in the drum to prevent any damage to the machine and to its

surrounding environment. Laundry should be rearranged and re-spun.

Programme time does not countdown.

• There might be an imbalance of laundry in the machine. >>> Automatic

unbalanced load detection system might be activated due to the unbalanced

distribution of the laundry in the drum.

Machine does not switch to spinning step when the laundry is not evenly

distributed in the drum to prevent any damage to the machine and to its

surrounding environment. Laundry should be rearranged and re-spun.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

BEKO WMB61221 Seite 32

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info